4.Connect the dispenser door tube ( 5 ) and, then insert a clip on the coupler while pulling tube.
Connect the connector ( 4 ) on the left side door and one connector ( 3 ) on the right side door.
The clip is enveloped inside of the top cap.
4
3
Red Clip
(1/4")
5 | Cabinet |
| Tube |
Dispenser
Door Tube
| dispenser door tube |
The dispenser door tube ( 5 ) must be fully inserted to the marked line to | coupler |
caution prevent water leakage from the dispenser. |
|
5.Position the top table ( 2 ) in place. Insert the 3 screws into the top table then, tighten with a philips screw driver (+). Open the door, reinsert the cap top table ( 1 ), and then close the doors.
When
After assembling, close the door and check to see whether the door has gaps between gaskets or is tilted.
If there is a problem, please refer to “Adjusting the doors” on page 18.
2
1
14_ setting up