Samsung RF323TEDBBC, RF323TEDBSR, and RF323TEDBWW Refrigerator Manual and Operating Guide

Operating your French Door Refrigerator

USING THE CONTROL PANEL

RF323TE**

( 4 )	Touching this button turns on the
Lighting/	Dispenser LED lamp (under the display)
Hold 3 sec	in continuous mode so that it stays on
for C↔F	continuously. The button also lights
	up. If you want the Dispenser lamp to
	come on only when some one uses the
	dispenser, touch this button to turn the

1

2

3

10

7

4

5

6

9

8

	continuous mode off. Touch and hold
	this button for 3 seconds to switch the
	temperature units between °C and °F.
( 5 ) Fridge	Touch this button to set the fridge to
(Hold 3sec	your desired temperature. You can set
for Power	the temperature between 34°F and 44°F
Cool)	(between 1°C and 7°C). Touch and hold
	this button for 3 seconds to decrease
	the time needed to cool products in
	the Refrigerator. It can be helpful if you
	need to quickly cool easily spoiled items
	or if the temperature in the fridge has

( 1 ) Energy	Touching this button turns Energy Saver
Saver	mode on and off. When you turn Energy
	Saver on, the Energy Saver icon lights.
	Turn Energy Saver off and the icon
	goes off. The Energy Saver function
	automatically turns on when power is
	supplied to the refrigerator.
	If condensation or water drops appear
	on the doors, turn the Energy Saver
	mode off.
( 2 ) Freezer	Touch this button to set the freezer to
(Hold 3 sec	your desired temperature.
for Power	You can set the temperature between
Freeze)	-8°F and 5°F (between -23°C and
	-15°C). Touch and hold this button for 3
	seconds to decrease the time needed
	to freeze products in the Freezer. It can
	be helpful if you need to quickly freeze
	easily spoiled items or if the temperature
	in the freezer has warmed dramatically
	(For example, if the door was left open).
( 3 ) Alarm	This button serves two purposes:

/hold 3sec 1) To turn the door open alarm on and off

for Filter	If the door alarm is set to On, an alarm
Reset	beeps if any refrigerator door is left
	open for more than three minutes.
	The beeping stops when you close the
	door. The door alarm function is pre-
	set to On in the factory. You can turn it
	off by touching and then releasing this
	button. You can turn it back on in the
	same fashion. The icon lights up when
	the function is on.
	2) To reset the water filter life indicator.
	After you replace the water filter, touch
	and hold this button for 3 seconds to
	reset the water filter life indicator.

12_ operating

	warmed dramatically (For example, if the
	door was left open).
( 6 ) Ice Off	If you don’t want to make more ice,
(Hold 3 sec	touch this button. Also, pressing this
for child	button for 3 seconds turns on Child
lock)	Lock which locks the display panel and
	dispenser buttons so the buttons can not
	be used. The Child Lock icon lights up to
	indicate you’ve activated the Child Lock
	function. Press 3 seconds to unlock.

(7)Cubed Press the Cubed Ice or Crushed Ice

Ice button to select the type of ice you

(8)Crushed want dispensed. Each time you press

Ice	the button, the cubed and crushed
	ice modes alternate and the Cubed or
	Crushed ice icon lights up, indicating
	your selection.
(Cubed) (Crushed)	If you don’t need ice, turn the function
	off to save on water and energy
	consumption (See Ice Off below).
Cooling Off	Cooling Off mode (also called Shop
Mode	mode), is designed for use by retailers
	when they are displaying refrigerators on
	the shop floor. In Cooling Off mode, the
	refrigerator’s fan motor and lights work
	normally, but the compressors do not
	run, and the refrigerator and freezer do
	not get cold. To start Cooling Off mode,
	touch and hold the Energy Saver button
	and the Freezer button for 5 seconds
	during normal operation. The refrigerator
	chime sounds and the temperature
	display flashes OF OF.
	To cancel Cooling Off mode, touch and
	hold the Energy Saver and the Freezer
	buttons again for 5 seconds.

DA68-02603A-03.indb 12 13. 4. 25.

�� 2:12