Mechanical Disassembly
Ice Dispenser & Ice Maker
The ice dispenser is located in the upper portion of the freezer. This assembly stores ice made by the icemaker and dispenses ice.
1.Lift the ice bucket up ① and slide out the ice dispenser assembly ②.
The ice maker is located inside of the ice dispenser assembly.
1.Remove ice maker support screws (2), and slide out.
2.Disconnect the ice maker wire connector.
3.Unlock the locking tabs to separate the ice maker kit.
SUPPORT OF
LOCKING TAB
WIRE CONNECTOR
In order to assemble the icemaker kit.
1.Assemble the geared motor shaft and the front of ice tray.
2.Lift the front locking tab and assemble the ice maker kit.
3.Connect the ice maker wire connector.
4.Match the tab holes and tabs(2) located on the
top of the liner, and slide the ice maker in.
5. Tighten the screws (2) of the ice maker support.
FRONT LOCKING TAB
TAB HOLES
FRONT OF ICE TRAY
GEARED MOTOR SHAFT
Auger Motor Case
This shelf is designed to support the ice maker ＆ ice dispensed and Xtra SpaceTM.
1.Remove the Xtra SpaceTM cover to push it down and pull front.
2.Slide the partition out.
3.Remove the screws (2) on the bottom front of the case.
4.Slide out the case while disconnecting the wire connect.
PARTITION
SCREWS
11