TROUBLESHOOTING
The refrigerator does not work at all or it does not chill sufficiently
•Check that the power plug is properly connected.
•Is the temperature control on the display panel set to the correct temperature? Try setting it to a lower tem- perature.
•Is the refrigerator in direct sunlight or located near a heat source?
•Is the back of the refrigerator too close to the wall?
Ice is not dispensed
•Did you stop the ice making function?
•Is there any ice in the ice storage unit?
•Is the water line connected and the
•Is the freezer temperature too warm? (Set the temperature lower)
•Did you wait for 12 hours after installation of the water supply line before making ice?
The food in the refrigerator is frozen
•Is the temperature control on the display panel set to the correct temperature? Try setting it to a warmer temperature.
•Is the temperature in the room too low?
•Did you store food with a high water content in the coldest part of the refrigerator?
You hear unusual noise or sounds
•Check that the floor is leveled and stable.
•Is the back of the refrigerator too close to the wall?
•Was anything dropped behind or under the refrigera- tor?
•A “ticking” sound may be heard from inside the refrig- erator, this is normal. This occurs because various accessories are contracted or expanded.
The front corners and sides of the cabinet are hot; condensation occurs.
•
•Condensation can occur when you leave the door open for a long time.
You can hear water bubbling in the refrigerator
•The bubbling comes from the refrigerant circulating in the refrigerator and is normal.
There is a bad smell in the refrigerator
•Wrap strong smelling food so that it is airtight. Throw away any rotten food.
Frost forms on the walls of the freezer
•Is the air vent blocked?
•Allow sufficient space between the foods stored for efficient air circulation.
•Is the door closed properly?
No water is supplied
•Is the water line connected and the
•Is the water supply line crushed?
•Is the water tank frozen because the refrigerator tem- perature is too low? Select a warmer setting on the display panel.
INSTALLATION INSTRUCTIONS
29