Samsung RS267LBSH owner manual Checking the Water Dispenser Line, Connecting to water supply line

Page 26

CHECKING THE WATER DISPENSER LINE

1)In order to operate the ice maker properly, water pressure of 20 ~125 psi is required. In this range a 170 cc (5.74 ounces) paper cup can be filled in 10 secs.

2)The water filter removes particles. It does not sterilize or destroy any micro-organisms.

3)If the refrigerator is installed in an area with low water pressure (below 20psi), you should install a booster pump to compensate.

4)Ensure the water storage tank inside the refrigerator is properly filled initially. Push the water dis- penser lever until the water runs from the outlet.

	Water line installation kit is available at extra cost from your dealer. The refrigerator
NOTE	manufacturer recommends using a water supply kit containing copper tubing.
NOTE

Connecting to water supply line

-Shut off the main water supply line and turn the Ice maker to the off position.

-Locate the nearest cold drinking water line.

-Follow the instructions in the ice maker installation kit.

-After connecting the water supply with water filter, turn on water supply and flush 4 or more gallons into a bucket to clear the water filter

1.Cold Water line

2.Pipe Clamp.

3.Water Line Installation Kit

4.Shut Off Valve

26

Image 26

Contents Side by Side Refrigerator Safety Warning Signs Safety Warning Signs Service center Setting UP the RefrigeratorMajor Features Twin Cooling SystemControl Panel RS263B**/RS265L**/RS264A RS265/RS267B**/RS267/RS269LDigital Panel This light goes on when you press the Power Cool buttonPress this button again to cancel the Power Cool mode Push the ice dispenser lever with a cup Temperature ControlCold Water Refrigerator Shelves and BinsFreezer Ice chute Tempered Glass Shelf Wire Shelf, RS263B**/RS265L**/RS264AFood Storage Guide Door Bin Tilt Pocket, RS265 / RS267B**/ RS267/ RS269LEgg Container on some models Wine Shelf RS265 / RS267B**/ RS267/ RS269L**/RS264ATempered Spill Proof Glass Shelf Chilled Bin or CoolSelect ZoneTM DrawerThat you do not want to thaw Quick Cool ButtonThaw Button Chill Select ButtonSoft Freeze CoolRemoving the Freezer Accessories Cleaning the Accessories One ➁ Changing the Interior LightTwin Deodorizer on some models Direction of the arrowOrdering Replacement Water Filter Water Filter Indicator lightUsing the dispenser without the water filter Water FilterHow to assemble the separable door handle optional Installation of the RefrigeratorChecking the Dimensions of your Entrance Door Selecting the Location for the RefrigeratorSeparating the Water Supply Line from the Refrigerator Removing the Refrigerator DoorsRemoving the Front Leg Cover Removing the Freezer Door Lift the door straight up Place doors on a protected surfaceRemoving the Refrigerator Door Reattaching the Refrigerator Doors Reattaching the Freezer DoorFirst Reattaching the Refrigerator DoorIt from the front part of the upper hinge cover Reattaching the Water Supply Line Reattaching the Front Leg CoverCase 2 Freezer door is higher than that of the refrigerator Leveling the RefrigeratorDoors will be uneven if the refrigerator is not level If the door of the freezer is lower than that Making small adjustments between doorsAdjust Leveling first RefrigeratorConnecting to water supply line Checking the Water Dispenser LinePosition. Do not overtighten Install the water filterConnect the water line to the refrigerator Installation of the Water Dispenser Line Check the amount of water supplied to the ice trayTroubleshooting Limited Warranty to Original Purchaser Memo