instaLLing tHE watEr DisPEnsEr LinE
For Exterior model
Parts for water line Installation
Water line fixer and | Pipe | Water line | Purifier |
|
|
|
screws | connector |
| Purifier |
Connecting to the water supply line
Connect the water pipe with coupler and tap.
1.Close the main water tap.
2.Connect coupler “A” to the tap.
WARRANTY INFORMATION
This water line installation is not covered by the refrigerator or ice maker manufacturer’s warranty. Follow these instructions carefully to minimise the risk of expensive water damage.
Note:
If the coupler does not fit on the current tap, go
the nearest authorised service dealer and purchase the right couplers fittings.
CAUTION
The water line must be connected to the cold water pipe. If it is connected to the hot water pipe, it may cause the purifier to malfunction.
COUPLER “A”
TAP
LINE OUTLET
select the location where the purifier is to install. (Model with the purifier)
-If you wish to reassemble the water inlet and outlet sides of the purifier during purifier installation, see the reference illustration.
-Cut the water line attached to the purifier to the appropriate place after measuring the distance between the purifier and the cold water tap.
Replacement Instructions
SIDE OF | 90 degree | ||
PURIFIER |
| CAUTION | |
|
| ||
PURIFIER WATER | Insert Locking Clip After | ||
tube seated | |||
|
| ||
WATER INLET | COUPLER | Locking Clip | |
SIDE OF PURIFIER |
| ||
|
| ||
| FLOW DIRECTION |
1. | Shut off water supply. | WATER SUPPLY |
|
|
|
|
| ||
|
|
| |||||||
|
|
|
|
|
|
| |||
| INLET SIDE | ||||||||
2. | Note the Flow direction on the filter. | ||||||||
|
|
|
|
|
| ||||
3. | Insert water supply tube into the inlet side of the filter until the tube stop. |
PERMEAT
Note : You must also ensure that the cut is square and not at any sort of angle as this could cause a leak
4.After inserting tube, put together the clip strongly. The Clip fix the tube.
5.Turn on the water and check for leaks. If leaks occur, repeat step 1,2,3,4. If leaks persist, discontinue use and call your supporting dealer.
6.Flush filter for 5 minutes before use.
20_ setting up