Parts Included with your Hood
•Hood Canopy Assembly with Ventilator and Light Bulbs Installed
•Care & Use /Installation Instructions
•Registration Card.
•Filters, 1, 2, 3 or 4 depending on model and size
•Plastic Transition with Back draft dampers installed
•Screws and Drywall Anchors
•2 Mounting Hooks
•Mounting Temple
•2 Piece Duct Cover
•Rubber Tape (only for HSW and HCSW model)
•6" or 8" Starting Collar
•Contents Sheet
•2 Rubber Gaskets
Parts Not Included with your Hood
•Metal Transition if required HGTR6 for HGSW model
HSTR6 for all other 400 CFM hoods
HDTR8 for HDW models
•Duct Tape
•1/2" Conduit
•Wire Nuts
•Plywood Wall Mounting Block
CONSIDERATIONS BEFORE INSTALLING HOOD
1.For the most efficient air flow exhaust, use a straight run or as few elbows as possible.
CAUTION: Vent unit to outside of building, only.
2.Use flex ducting only to connect rigid duct directly to transitions.
3.COLD WEATHER installations should have an additional backdraft damper installed to minimize backward cold air flow and a nonmetallic thermal break to minimize conduction of outside temperatures as part of the ductwork. The damper should be on the cold air side of the thermal
break. The break should be as close as possible to where the ducting enters the heated portion of the house.
4.Hood installation height above cooktop is the users preference. The lower the hood above the cooktop, the more efficient the capturing of cooking odors, grease and smoke. Thermador recommends the hood be installed
Page 4