Alternate - reduced ceiling height Installation for HDW and HTSW and HGSW models:
The hood may be installed with only the lower part of the duct cover to reduce the overall height. This hood height is signified by * in Table 1. For the duct cover to slide down and engage the top of the hood, the ceiling bracket must be mounted 1/4" below the ceiling. The resulting space on top of the chimney can be filled with a 1/4” thick piece of plywood cut to the inside cross section of the chimney
cover and finished to match the ceiling.
Copy the two mounting holes on the sides of the upper cover to the lower cover.
Rear discharge:
A 90° elbow may be installed immediately above the hood. For serviceability, a mounting similar to the straight up discharge shown in Fig. C should be used. In Table 1 dimension "T" signifies distance from hood bottom to top of transition.
Page 8