ColdTech JDD-58, JBB-58, JBB-80, JDD-80 Temperature Controls, Light Switch Operation, Off

evaporator cover

interior drain fitting

exterior drain fitting

TEMPERATURE CONTROLS

The temperature controls are factory-set to maintain an average temperature of 38 F in refrigerators and 0 F in freezers. To maintain a different temperature, simply adjust the control knob located inside the unit. To decrease the temperature (colder), turn clockwise. To increase the temperature (warmer), turn counter-clockwise - see diagram

T emperatures range

from 7 (coldest) to 1

6

7 5

OFF4

13

2

TEMPERATURE

READING

C A UT ION

Setting the temperature control to the coldest setting may cause the evaporator coil to freeze and ice up. This will eventually result in a warmer cabinet temperature.

LIGHT SWITCH OPERATION

The light switch is located beneath the temperature control, on the evaportor		ON
cover, which is located inside of your unit, against the right hand wall.
1)	To turn on the light, simply move the toggle switch to "I"
2)	To turn off the light, simply move the toggle switch to "O"	OFF

It is recommended that you turn off the light, whenever possible. This will allow the unit to operate more efficiently and reduce your electricity costs.

BEER DRAIN CONNECTION (APPLICABLE ON "JDD" MODELS ONLY)

You will notice that your new direct draw unit comes with a plastic bottle, which will collect excess drips or overpours from the drip tray. Your unit also comes equipped with an exterior drain option, which will bypass the use of the bottle, if you

would like to allow for the excess dripping to drain to an external source (such as a floor drain). Simply disconnect the bottle and connect the drain tube into the fitting located on the lower right front corner of the interior,

underneath the evaporator cover.

Connect a hose (not provided) to the fitting located beneath the right door

on the exterior (as shown) and drain through any source to your liking.

-4-