Philips MRD120 manual Playing a disc, No picture?, Using the DVD setup menu

Playing a disc

4 ALL

AV IN

STANDBY-ON	PLAY/PAUSE	STOP	PROG	PHONES
	OPEN/CLOSE
	PREV	NEXT	SOURCE
				VOLUME

4	CH
	AN
	NEL
	3

3	Make sure your DVD system and	2
	TV are connected and turned on!

1	1 Press DISC on the remote control.
	You can also press the SOURCE button on the front panel
	until “DISC” appears on the display panel.

No picture?

4

5

VOL

2

3

4

5

Turn on the TV and select the correct Video In mode.

You should see the blue DVD background screen on the TV (if no disc in the DVD system).

Press OPEN/CLOSE 0 on the front of the

DVD system and load a disc, then press OPEN/CLOSE 0 again to close the disc tray.

Make sure the disc label is facing up. For double-sided discs, load the side you want to play face up.

Press ÉÅ to start playback.

If a disc menu appears, use 3 4 1 2 buttons on the remote to make the necessary selection, then press OK to confirm. Or, use the numeric keypad on the remote to select features. Follow the instructions given in the disc menu.

To stop playback, press STOPÇ.

Check the AV (Audio/Video)

mode on your TV.

*Usually this channel is between the lowest and highest channels and may be called FRONT, A/V IN, or VIDEO.

*Or, you may go to channel 1 on your TV, then press the Channel down button repeatedly until you see the Video In channel.

*Or, your TV remote control may have a button or switch that chooses different video modes.

*Do not use channel 3 or 4 on the TV unless you are using an RF modulator.

*See your TV manual for more details.

Using the DVD setup menu

➠ ➠

➠	TV SHAPE
	TV SYSTEM
	VIDEO OUT
	SCR SAVER

STANDBY-ON	PLAY/PAUSE	STOP	PROG	PHONES
	OPEN/CLOSE
	PREV	NEXT	SOURCE
				VOLUME

1

2

DIGITAL OUT

NIGHT MODE

CNTR DELAY

REAR DELAY

TEST TONE

AUDIO

SUBTITLE

DISC MENU

PARENTAL

PASSWORD

MENU LANG

DEFAULTS

Press to remove the menu.

Detailed playback features and additional functions are described in the

accompanying owner’s manual.