Installing under a worktop
•Adjust the feet to the required height.
•Push the appliance into the niche until the decor door is flush with the adjacent furniture items, adjust the feet if necessary.
•
Adjusting the plinth depth (figure 6)
•Lift out the decor door.
•Grip the plinth at the ventilation grille and align until flush with adjacent furniture items, or join up to the continuous plinth if fitted. Cut away the continuous plinth trim as illustrated for ventilation.
Never cover over the ventilation slots.
Once installed the plinth must not block the ventilation slots in the appliance. This may require cutting the plinth down. Failure to ensure adequate ventilation may invalidate the warranty.
•Attach the appliance plinth at screws (5),
turning screws clockwise until considerable resistance is felt (figure 7).
• To adjust the plinth height, turn the screws
Adjusting the decor door
•Position the decor door on the appliance. Open loose locking nuts.
•Adjust height Y at locating pin (14mm wrench) as shown in figure 8, Y=max +/- 3.5mm.
•Adjust side measurement X at slots on mounting bracket at top, X=max, +/- 3mm.
•Open out lower locating pins until contact is made with the mounting plate. Secure with locking nuts.
•If necessary, adjust the alignment of the lower decor panel edge at 10x12 hole in mounting bracket, Z= +/- 2MM. Then tighten the locking nuts again.
•Push on cover trim (6) and engage (to remove, lever out the trim strip with a screwdriver as illustrated in figure 9).
•When aligned, secure the appliance to the worktop at retaining slots.
Important: The cover trim (6) must be fitted as this turns off the light when the door is closed.
fig. 6
5
fig. 7
fig. 8
fig. 9