Philips MX3600 warranty First Time Setup, Where Do You Start?, Antenna Connections

Page 9
Remove the battery compartment lid by pressing in the tab, then lifting off the lid.
Put the batteries in the remote control and connect the AM and FM antennas as detailed below.

Where Do You Start?

Disconnect all equipment from power. Connect equipment to

1 power only after you have finished hooking up everything. Do not change connections with equipment connected to a power outlet.

2

Connect the DVD Receiver to a Television using one of the

3 options detailed in your separate Quick-Use Guide (or on pages 10-12).

●You need only one video connection between the DVD Receiver and the TV. Use Composite Video (good picture quality), S-Video (better picture), or Component Video (best picture). Use the best connection available with your TV.

●Set the TV to the correct VIDEO IN channel. Such channels may be called AUX(iliary) IN, AUDIO/VIDEO (A/V) IN, EXT1, S- VIDEO, etc. These channels are often near channel 00 on your TV. Or, your TV remote control may have a button or switch that chooses different Video modes. With some TVs, you use the TV’s menu to select a Video mode. See your TV manual for details.

Connect the speakers and Subwoofer to the DVD Receiver

4 as detailed in your Quick-Use Guide (or on page 13).

First Time Setup 9

Note: If your TV only has a single Antenna In(put) jack, you will need an accessory RF Modulator to view the DVD playback on your TV. See your electronics retailer or contact Philips for details on RF Modulator availability.

75 ￿

Rear of TV

Battery Installation

1

Place the batteries in the battery compartment, matching

2 the +/- markings on the batteries to the +/- markings inside the remote.

3 Replace the battery compartment lid.

Antenna Connections

Connect the supplied AM loop antenna to the AM jack on

1 the rear of the DVD Receiver.

●Reposition the loop antenna to receive the clearest sound for area stations. Attach the antenna to the base stand if desired.

1 3

2

Put the claw into the slot.

Connect the supplied FM antenna to the FM jack on the

2 rear of the DVD Receiver. Extend and adjust the antenna until the clearest station signal is received. For better FM reception, use a 75 ohm coaxial cable (not supplied) to connect the DVD Receiver to an outdoor FM antenna as shown.

OR

AM

FM

(75 Ω)

Outdoor FM

Antenna

(not supplied)

Helpful Hint

•To prevent unwanted noise, keep the antenna as far away as possible from the TV, VCR, or any other radiation source.

Page 8 Page 10
Image 9
Page 8 Page 10
Contents MX3600D MX3700D Registration Card within 10 days. So please mail Exclamation point callsModel No Serial No Table of Contents Installation Safety InformationCopyright Protection Federal Communications Commission FCCIntroduction Remote Control Front Panel Connect to a standard AC outlet Rear PanelFirst Time Setup Where Do You Start?Antenna Connections Hookups TV Connecting to a TV with a Composite yellow Video In JackTo hear TV channels through the DVD Home Cinema System Turn on the TV and set it to the correct Video In channelHookups TV cont’d Connecting to a TV with Component Video In JacksConnect the DVD Receiver’s Pr/Cr Pb/Cb Y Component Turn on the TV and set it to the correct Component VideoConnecting to a TV with an S-Video In jack Turn on the TV and set it to the correct S-Video In chanIt is not necessary to set Video OUT to S-VIDEO Hookups Speakers Connecting the SpeakersHookups Optional Connecting to a TV and Optional Audio EquipmentConnect the DVD Receiver to a TV as shown on pages Connect the DVD Receiver’s Audio OUT jacks toConnect the DVD Receiver’s Audio OUT L/R jacks to Connecting to a VCR or Cable/Satellite BoxAudio in L/R jacks on the VCR Connect the DVD Receiver’s Video OUT jack to the VideoDVD Disc Menus Quick Disc PlaybackPausing Playback Playback FeaturesSystem Menu System Menu IconsTo exit, press System Menu or OK Subtitles Subtitles, Audio LanguageAudio Language Press System MenuSlow Motion, Searching Slow MotionSearching Title/Chapter Selection Title/Chapter Selection, Time SearchPress System Menu Press or to select Title or Press System Menu to remove the Menu BarStatus, Zoom StatusZoom Angle, Step AngleStep MP3 Features Playback Control, MP3 FeaturesPlayback Control Video CD only Press or to select Press 9 to select PBC on or PBC OFFDuring DVD playback, press Repeat on the remote to play a Repeat, Repeat A-BDuring Video CD, Audio CD, or MP3 playback, press To resume regular playback, press Repeat A-B againWhile playback is stopped, press Program on the DVD Favorite Track SelectionTV System NTSC, PAL TV Shape Screen Saver Screen Saver, Video OutVideo Out Scart option is not available for this DVD ReceiverNight Mode Digital Output, Night ModeDigital Output Press 9 repeatedly to select z, then pressChoose Rear Delay if Speaker SettingsWhile playback is stopped, press System MENU. Press Choose Test Tone if youDVD Audio, Subtitle, and Disc Menu Languages Language SettingsParental Control Levels Press the Number buttons 0-9 on the remote control toParental will be selected. Press Press 9 or 8 to select a Parental Control Level, then pressParental Control Password Parental Control Password, DefaultsDefaults Are asked to enter the code for the first timeAdjusting the Volume Audio and Sound FeaturesAdjusting Bass and Treble Changing Surround Speaker Volume LevelsSurround Sound Options Selecting Surround SoundPress Surround repeatedly to select a surround sound Selecting Preset Radio Stations Tuning Radio StationsRadio Stations Programming Radio StationsSleep Timer Helpful Hints Helpful Hints cont’d Specifications are subject to change without notice SpecificationsFront speakers/Surround speaker Center SpeakerCD Compact Disc audio GlossaryZoom IndexAudio System Limited Warranty
Top Page Image Contents