Blomberg IWD 1004 ET, KWD 9440 XA++ Always use the water filter when a jug is not being used

Page 20

C Pumps must be used in case the supply water pressure drops below 1 bar or if a jug is going to be used.

C Water system of the refrigerator must be connected to the cold water line. It must not be connected to hot water line.

C No water may be obtained in the initial startup of the refrigerator. This is caused by the air in the system. To discharge air from the system, press Dispenser latch for periods of 1 minute until water comes from the Dispenser. Water flow may be irregular in the beginning. Irregular water flow will be normalized after the air in the system is discharged.

C At the initial startup of the refrigerator approx.12 hours must pass before cold water can be obtained.

C Water mains pressure must be between 1-8 bars for the operation of Ice/Water Dispenser smoothly. For this, check that 1 glass of water (100 cc) can be filled in 10 seconds.

C The first 10 glasses of water should not be consumed.

C 12 hours must pass to obtain ice from the Ice Dispenser for the first time. If there is not enough ice in the ice dispenser, ice may not be obtained from ice dispenser.

C Approximately the first 30 cubes of ice to be obtained from the Ice Dispenser must not be used.

C Always use the water filter when a jug is not being used.

19

EN

Image 20

Contents Page Contents Using your refrigerator Your RefrigeratorYour Refrigerator Optional Important Safety Warnings General safetyIntended use Do not put bottled and canned liquidPage Child safety HCA WarningRefrigerator door Never dispose the product in fireThings to be done for energy saving Always remember InstallationBefore operating your refrigerator Placing and Installation Electric connectionDisposing of the packaging Disposing of your old refrigeratorFloor balance adjustment Door height adjustmentIf your refrigerator is unbalanced Remove the lower ventilation cover byAdjusting the gap between Situation should be made to take care Because of being wires in the hingeUpper door Installing Water Filter Installation RequirementsSome models Water connection to the refrigeratorConnection of the Water Pipe to the Refrigerator Mode is active before taking out the by- pass cover Compartment by pulling it forward. FigureConnection of the Water Pipe to the Cold Water Mains Line Water filter or installing the by-pass coverConnection of Water Hose to the Jug Prior to first use of Ice/Water Dispenser Separate the union from the tap adaptor. Figure aAlways use the water filter when a jug is not being used Preparation Using your refrigerator Water Dispenser light button Water Dispenser LightsSetting the fridge compartment temperature Setting the freezer compartment temperatureFresh Freeze Function Quick Cool FunctionVacation Button IonizerKey Lock Button Water Dispenser IlluminationUsing the Ice Dispenser Ice OffSliding Body Shelves Using the water springSpillage Tray Using the crisper humidity control sliders Blue lightEgg tray Fresh Freeze CompartmentReplacing the Interior Light Bulb Recommendations for preservation of frozen foodDefrosting Page Maintenance and cleaning Protection of plastic surfacesChill compartment Icebox and Water Dispenser Minibar Recommended solutions for the problems Page Vibrations or noise Page 48 8425 0002/AD

Related manuals

Manual 601 pages 47.78 Kb