Blomberg KWD 9440 XA++, KWD 9440 X A+, KWD 9330 X A+, IWD 1005 XT, IWD 1004 XT Preparation

Page 21

4Preparation

CYour refrigerator should be installed at least 30 cm away from heat sources such as hobs, ovens, central heater and stoves and at least 5 cm away from electrical ovens and should not be located under direct sunlight.

CThe ambient temperature of the room where you install your refrigerator should at least be 10°C. Operating your refrigerator under cooler conditions than this is not recommended with regard to its efficiency.

CPlease make sure that the interior of your refrigerator is cleaned thoroughly.

CIf two refrigerators are to be installed side by side, there should be at least 2 cm distance between them.

CWhen you operate your refrigerator for the first time, please observe the following instructions during the initial six hours.

-The door should not be opened frequently.

-It must be operated empty without any food in it.

-Do not unplug your refrigerator. If

a power failure occurs out of your control, please see the warnings in the “Recommended solutions for the problems” section.

COriginal packaging and foam materials should be kept for future transportation or moving.

20

EN

Image 21
Contents Page Contents Your Refrigerator Using your refrigeratorYour Refrigerator Optional General safety Important Safety WarningsIntended use Do not put bottled and canned liquidPage HCA Warning Child safetyRefrigerator door Never dispose the product in fireThings to be done for energy saving Installation Before operating your refrigeratorAlways remember Electric connection Placing and InstallationDisposing of the packaging Disposing of your old refrigeratorDoor height adjustment Floor balance adjustmentIf your refrigerator is unbalanced Remove the lower ventilation cover byAdjusting the gap between Because of being wires in the hinge Upper doorSituation should be made to take care Installation Requirements Installing Water FilterSome models Water connection to the refrigeratorConnection of the Water Pipe to the Refrigerator Compartment by pulling it forward. Figure Mode is active before taking out the by- pass coverWater filter or installing the by-pass cover Connection of Water Hose to the JugConnection of the Water Pipe to the Cold Water Mains Line Separate the union from the tap adaptor. Figure a Prior to first use of Ice/Water DispenserAlways use the water filter when a jug is not being used Preparation Water Dispenser light button Water Dispenser Lights Using your refrigeratorSetting the freezer compartment temperature Setting the fridge compartment temperatureFresh Freeze Function Quick Cool FunctionIonizer Vacation ButtonKey Lock Button Water Dispenser IlluminationIce Off Using the Ice DispenserUsing the water spring Spillage TraySliding Body Shelves Blue light Using the crisper humidity control slidersEgg tray Fresh Freeze CompartmentRecommendations for preservation of frozen food DefrostingReplacing the Interior Light Bulb Page Protection of plastic surfaces Maintenance and cleaningChill compartment Icebox and Water Dispenser Minibar Recommended solutions for the problems Page Vibrations or noise Page 48 8425 0002/AD
Related manuals
Manual 601 pages 47.78 Kb