Amana ACF4255A owner manual Oven temperature control adjustment, Service codes and tones

Page 12

Features

F-

 

code

Possible Meaning

 

 

F0-0

No error

 

 

F1-1

Cooking temperature fault

 

 

F1-3

Cleaning temperature fault

 

 

F1-5

Cancel key input out of range

 

 

F1-7

Keyboard disconnected

 

 

F1-8

Shorted key

 

 

F1-9

Slave micro not functioning

 

 

F1-A

VCC/GNDD lift-off

 

 

F1-C

Control not calibrated

 

 

F1-E

EEPROM data corruption

 

 

F3-1

Sensor or circuit error

 

 

F9-1

Auto latch will not lock

 

 

F9-2

Auto latch will not unlock

 

 

Oven temperature control adjustment

Your range is calibrated at the factory for proper temperature. Due to individual variances and preferences, it may be necessary to adjust ovens once they have been installed.

When first using the oven, follow recipe times and temperatures. Before adjusting oven baking temperature, test a recipe, such as ready-to-bake biscuits, by setting oven temperature higher or lower than the suggested temperature. The baking results should help you to decide how much of a temperature adjustment is required.

An accurate digital thermometer is necessary to calibrate the oven. Store purchased oven thermometers may not accurately measure oven temperature. Oven temperature can be increased or decreased by 35°F. To avoid over adjusting the oven, only adjust the temperature by 5°F each time.

NOTE: DO NOT place aluminum foil on racks and oven bottom as this will alter oven performance. Check for blocked heat vents. If it still appears the oven is not performing as expected, a calibration may be done.

1.Press BAKE pad.

2.Using the digit pads, enter “500”.

3.Press and hold BAKE pad for approximately 3 seconds.

4.A double digit offset temperature will display. Factory default is normally 0The e degrees.

•Press BAKE key to adjust the temperature change in 5° increments.

•Temperature will wrap around from positive to negative numbers.

•When temperature is adjusted to a cooler setting, a minus sign (-) will display with the offset temperature.

5.To set the temperature change, press START pad. To cancel the change, press CANCEL pad.

•Offset temperature change will be retained through a power failure.

Service codes and tones

The electronic oven control is equipped with a self-diagnostic system.

The self-diagnostic system alerts you if there is an error or problem with the unit. If electronic range control sounds a series of short, rapid beeps for over 16 seconds and display shows an F-code, record the F-code shown. Some F-codes can be cleared by pressing cancel or disconnecting power to the range for at least 3 minutes. If the code continues to reoccur disconnect electrical supply to range and contact an authorized servicer.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Contents Covering TMACF4255A and TMACF4265A Electric Smoothtop RangeQuestions on cooking, cleaning or usage? Thank you for buying an Amana RangeRefer to Call Consumer Affairs atImportant Safety Information Important Safety Information cont’d Cooking UnitsPrecautions Case of FireSurface Element Fire Oven FiresSetting Surface Element Controls Indicator LightsCooking on the Smoothtop Dual Surface ElementsUsing the Warming Zone Temperature SelectionIndicator Light Cooking on the Smoothtop contdCookware Suggestions What Should You Consider in Cookware?Flat Pan Test Can I can?Oven Cooking Methods Oven Cooking MethodsBroiling Hints Before Using the Oven Oven Racks and Rack PositionsAluminum Foil Rack Position Guidelines for Baking, Roasting and BraisingFeatures Hour automatic cancelSabbath mode Child lockoutOven temperature control adjustment Service codes and tonesCode Possible Meaning Timer Signal Preheat SignalEnd-of-Cycle Signal There are words in the display that never actually displayUsing the Oven Control Setting Electronic ClockSetting Minute Timer Resetting and Canceling TimerUsing the Oven Control cont’d How Do I Change the Temperature?Why is the oven smoking? BakingDelayed Baking Whats the difference between Timed and Delayed cooking?How Far Ahead Can I Set the Time? How much time is left?Self-cleaning Interrupting the self-clean cycleDo I need to prepare? Delayed Self-clean Cycle Cooking Baking GuidelinesCommon Baking Problems Cooking cont’dIt may not be the oven Cake stuck?Using a Meat Thermometer Handling Hints Cooking Tips Storage SafetyMeat Basics TenderizingBroiling Guidelines BeefRoasting Guidelines BeefPork LambBraising Guidelines Care and Cleaning Care and Cleaning cont’d Replacing Oven LightPart General Directions Problem Cause Removal Caring for the smoothtopCleaning Stainless Steel Can I use liquid cleaners on my stainless steel?For best cleaning results Or call Consumer Affairs atTroubleshooting Topic Possible Cause SolutionTroubleshooting cont’d AppearancePage Amana Warranty Limited Warranty
Top Page Image Contents