Amana W10366212A Refrigerator Doors and Drawer, Standard Door, French Doors

Page 6

Refrigerator Door(s) and Drawer

TOOLS NEEDED: ⁵⁄₁₆", ³⁄₈", ¹⁄₄" hex head socket wrench, a Torx®† T20 screwdriver, a #2 Phillips screwdriver, and a flat-blade screwdriver.

IMPORTANT:

■Your refrigerator may have a standard reversible refrigerator door with either a freezer door or freezer drawer, or French doors. Follow the instructions specific to the door style of your model.

■All graphics referenced in the following instructions are included later in this section after “Final Steps.” The graphics shown for the standard door are for a right-hand swing refrigerator (hinges factory installed on the right).

■If you only want to remove and replace the doors, see “Remove Door(s) and Hinges” and “Replace Door(s) and Hinges.”

■Before you begin, turn the refrigerator control OFF, and remove food and adjustable door or utility bins from the doors.

Remove and Replace Refrigerator Door Handles

Standard Door

■To remove the handle, remove the screw attaching the trim to the upper end of the handle. Using a flat-blade screwdriver wrapped in masking tape, pry the trim piece from the lower end of the handle. Then, remove the screws attaching the handle to the door. See Graphic 2.

■To replace handle, reverse directions.

French Doors

Style 1 Handles

■Using a ³⁄₃₂" or ¹⁄₈" hex key, loosen the two setscrews located on the side of each handle. Pull the handle straight out from the door. Make sure you keep the screws for reattaching the handles. See Style 1 Handle, graphic 1.

■To replace the handles, reverse the directions.

Style 2 Handles

■To remove the handle, grasp the lower part of the handle firmly, slide the handle up and pull the handle straight out from the door. See Style 2 Handle, graphic 1.

■To replace the handle, position the handle so that the large holes in the mounting clips are down and align the holes with the door studs. Rotate the handle so that the mounting clips are flat against the door and slide the handle down to engage. See Style 2 Handle, graphic 1.

Remove Door and Hinges

Standard Door

⁵⁄₁₆" Hex-Head Top Hinge Screw

Freezer drawer models

1.Unplug refrigerator or disconnect power.

2.Keep the refrigerator door closed until you are ready to lift it free from the cabinet.

NOTE: Provide additional support for the door while the hinges are being moved. Do not depend on the door gasket magnets to hold the door in place while you are working.

3.Remove the parts for the top hinge as shown in Top Hinge graphic. Lift the refrigerator door free from the cabinet.

4.Remove the parts for the bottom hinge as shown in Bottom Hinge graphic.

Freezer door models

1.Unplug refrigerator or disconnect power.

2.Keep the freezer door closed until you are ready to lift it free from the cabinet.

NOTE: Provide additional support for the door while the hinges are being moved. Do not depend on the door gasket magnets to hold the door in place while you are working.

3.Remove the parts for the top hinge as shown in Top Hinge graphic. Lift the refrigerator door free from the cabinet.

4.Remove the center hinge pin and remove the hinge screws as shown in the Center Hinge graphic. Lift the freezer door free from the cabinet.

5.Remove the base grille by grasping the grille firmly with both hands and pulling it toward you.

6.Remove the parts for the bottom hinge as shown in Bottom Hinge graphic.

French Doors

WARNING

Electrical Shock Hazard

Disconnect power before removing doors.

Failure to do so can result in death or electrical shock.

1.Unplug refrigerator or disconnect power.

2.Keep the refrigerator doors closed until you are ready to lift them free from the cabinet.

NOTE: Provide additional support for the refrigerator door while the hinges are being removed. Do not depend on the door gasket magnets to hold the door in place while you are working.

†®TORX is a registered trademark of Saturn Fasteners, Inc.

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Refrigerator Safety Refrigerator User InstructionsInstallation Instructions Unpack the RefrigeratorBefore You Throw Away Your Old Refrigerator or Freezer Electrical Requirements Clean Before UsingLocationRequirements Recommended Grounding MethodReverse Osmosis Water Supply Water Supply RequirementsConnect the Water Supply Tools NeededStyle Connect to RefrigeratorRefrigerator Doors and Drawer Standard DoorFrench Doors Refrigerator door Reverse Door Standard Door optionalCabinet Freezer doorRemove and Replace Drawer Handle Remove Drawer FrontReplace Drawer Front Door Removal Replacement Door Swing Reversal optional Standard DoorDrawer Front Removal Drawer Front Replacement Refrigerator USE Door Closing and Door AlignmentOpening and Closing Doors Ice Maker Using the ControlsCrisper Humidity Control To Turn Off/OnWater Dispenser CleaningRefrigerator Care Water Filtration SystemChanging the Light Bulb TroubleshootingTo Clean Your Refrigerator Refrigerator OperationIce and Water Temperature and MoistureTemperature is too warm Doors will not close completelyWater from the dispenser is warm Water dispenser will not operate properlyIs the water pressure at least 35 psi 241 kPa? The water Recently dispensed large amount of water? Allow 24 hoursPerformance Data Sheets Application Guidelines/Water Supply ParametersModel UKF8001AXX-200 Capacity 200 Gallons 757 Liters Items Excluded from Warranty Amana Major Appliance WarrantyLimited Warranty This limited warranty does not coverInstructions Dutilisation DU Réfrigérateur Sécurité DU RéfrigérateurAvant de jeter votre vieux réfrigérateur ou congélateur Instructions D’INSTALLATIONDéballage duréfrigérateur Nettoyage avant l’utilisationExigences demplacement Méthode recommandée de mise à la terreSpécifications électriques Alimentation en eau par osmose inverse Spécifications de l’alimentationen eauRaccordement de la canalisation deau Outillage RequisAchever l’installation Raccordement au réfrigérateurPortes et tiroir du réfrigérateur Porte standardPorte à deux battants Porte du compartiment de réfrigération Réinstallation Porte et charnièresCaisse Porte du compartiment de congélationPortes à deux battants Dépose et réinstallation de la poignée du tiroirRéinstallation de la façade du tiroir Dépose de la façade du tiroirInversion du sens douverture de la porte facultatif Porte standardCharnières supérieures Portes à deux battantsFermeture et alignement de la porte Utilisation DU Réfrigérateur Utilisation des commandesHumidity Control Commande dhumidité sur certains modèles Ouvertureet fermeture des portesDistribution d’eau Machine à glaçonsDistributeur d’eau Mise en marche/arrêt de la machine à glaçonsSystème de filtrationde leau Remplacement del’ampoule d’éclairageEntretien DU Réfrigérateur NettoyageLe réfrigérateur ne fonctionne pas DépannageFonctionnement du réfrigérateur Le moteur semble trop tournerTempérature et humidité Glaçons et eauHeures pour la fabrication de nouveaux glaçons Feuilles DE Données SUR LA Performance Système de filtration d’eau intérieurModèle UKF8001AXX-200 /Capacité 200 gallons 757 litres Garantie Limitée Éléments Exclus DE LA GarantieLa présente garantie limitée ne couvre pas W10366212A SP PN W10366213A 2011 All rights reserved. Tous droits réservés

W10366212A specifications

The Amana W10366212A is a standout refrigerator designed for modern kitchens, combining efficiency, style, and advanced technology to meet the demands of contemporary households. This model exemplifies the well-established reputation of Amana for producing high-quality home appliances that cater to both functionality and aesthetics.

One of the main features of the Amana W10366212A is its spacious interior. With ample storage space, this refrigerator is equipped with adjustable shelves that can be moved to accommodate various food items, from large casseroles to towering bottles of soda. The refrigerator section also includes crisper drawers that help keep fruits and vegetables fresher for a longer period, ensuring that you can enjoy your groceries without worrying about spoilage.

In terms of technology, the Amana W10366212A features a reliable cooling system that maintains consistent temperatures throughout the fridge and freezer compartments. This ensures that food remains at optimal storage temperatures, prolonging its shelf life. The refrigerator is designed with energy efficiency in mind, which not only helps reduce utility bills but also contributes to environmental conservation.

One of the most notable characteristics of this model is its user-friendly interface. The Amana W10366212A is equipped with easy-to-use temperature controls, allowing users to set the desired cooling levels effortlessly. Additionally, the appliance features a sophisticated air circulation system that minimizes odors by maintaining optimal humidity levels, ensuring that your food tastes fresh.

The exterior of the Amana W10366212A is sleek and modern, available in a variety of finishes to complement different kitchen decors. The fingerprint-resistant stainless steel finish is particularly popular, as it maintains its shine while reducing the visibility of smudges and fingerprints.

Another appealing aspect of this refrigerator is its warranty and customer support. Amana offers robust customer service options, ensuring that if any issues arise, assistance is readily available.

Overall, the Amana W10366212A fridge is a perfect blend of functionality, advanced technology, and stylish design, making it an ideal choice for families looking to upgrade their kitchen appliances without compromising on style or effectiveness.
Top Page Image Contents