Amana L0503010 installation instructions SmoRIRG TRtDISRWASRtR

WATER VALV

O Remove shipping plug from water hflet valve,

OInstall a 90 ° elbow (3/8" N,P.T) fitting h, to the water valve using Teflon r'_ tape or pipe thread compound. The opposite end of"the fitth*g should fit h_-eoming hot water supply line. Position the end of the elbow towards the rear of the dishwasher

IMPORTANT: DO NOT connect a sweat type fitting directly to the water valve as the required beat will damage the water inlet valve. Do not solder within 6" (15.2 era) from the water valve.

CAUTION:With the door open, dishwasher may tip forward if it is not se<ure in position to cabinet,

:, RAIR ROSEPREPARATION

_}

_,:_:..

Diagram A

Dishwasher drain must bave a 32" (812) loop. Drain hose may be clipped to either skle of the disbwasber (see diagram A) It is preferred that the drain bose be routed high enough to provide the 32" loop. If a loop eammt be put in the installation, an air gap (not included) may be used.

IMPORTANT: Routing of the drain hose is most important to insure satisfactory operation. It is not recommended to extend drain line beyond 7' (2.1 m). Howevei; sbou[d this be necessary, it must always be attached to a hne of larger inside diametel: An accessory drain hose extension kit (#904204) is available through your autborized dealel: DONOT route drain hose across the top of the tub, all bends must be gradual to prevent kinking or co!lapsing of the hose,

IMPORTANT: Drain bose may change position even after installation, To insure proper operation, secure hose

to either side of cabinet wail, or to rob with bose dip (provided) to assure a 32" loop. Make certain there are no kinks.

	IMPORTANT:	I)o not	attach	the drain	bose to any connection	smaller than 1/2"	I.D.
(Shle view of dishwasher)	IMPORTANT:	Never	cut the	corrugated	portion of drain hose.	All connections
	must be made	to rubber	portions of drain		hose. If cutting of drain	bose is required,	--	.............. \
	do not cut past the 5/8" line.						Mtflti	flex Drain Hose

DRAN

A 5/8" (1.6 era) LD (Inside Diameter) x 7 ft. (2.1 m) corrugated drain hose is positioned on side of dishwasher tub.

Drain hose	connection	can	be located on either		Mde of compartment.		Elevate	drain hose
to a height of at least		32"	(81 era) above	the	f'loox: If drain connection is to be made
below the	floor; bose sbouM be left in the			looped position. It may		be necessary		to extend
drain bose	for connection.		DONOT reduce	the	drain hose to less	than	1/2" (1.3 cm) I.D.

(Inside Diameter).

+d+++........

{ ' smoRIRG TRtDISRWASRtR

_1_ With the door latched, position dishwasher h* front of cabinet opening. Insert drain bose through the opening provided_

Guide disbwasher into the cabinet, puHh_gdrah_ hose through opening as you proceed. Make sure drain bose is not kinked.