INSTALLATION REQUIREMENTS
ToolsandParts
Gather the required tools and parts before starting installation. The parts supplied are in the washer drum.
Tools needed for connecting the water inlet hoses
■Pliers (that open to 1⁹⁄₁₆" [39.5 mm])
■Flashlight (optional)
Tools needed for installation
■Open end wrench 17 mm and 13 mm
■Level
■Wood block
■Ruler or measuring tape
Parts supplied:
Beaded strap | Transport bolt hole plug (4) |
Alternate Parts
Your installation may require additional parts. If you are interested in purchasing one of the items listed here, call the
If You Have | You Will Need to Buy |
|
|
Laundry tub or | Sump pump system (if not already |
standpipe taller | available) |
than 96" (2.4 m) |
|
|
|
Overhead sewer | Standard 20 gal. (76 L), 30" (76.2 cm) |
| tall drain tub or utility sink and sump |
| pump (available from local plumbing |
| suppliers) |
|
|
Floor drain | Siphon break, Part Number 285834; |
| additional drain hose |
| Part Number 8318155; and connector |
| kit, Part Number 285835 |
|
|
Drain hose too | 4 ft (1.2 m) drain hose extension kit, |
short | Part Number 285863 |
|
|
Water faucets | 2 longer water fill hoses: |
beyond reach of | 6 ft (1.8 m) Part Number 76314, |
fill hoses | 10 ft (3.0 m) Part Number 350008 |
|
|
Options
Pedestal
You may order a pedestal separately for this washer. This pedestal will add about 13" (33 cm) to the height of your unit for a total height of approximately 51" (130 cm).
Optional pedestal
To order, call the dealer from whom you purchased your washer or refer to the “Assistance or Service” section of this manual.
13" (33 cm) Pedestals
Color | Part Number |
WhiteLAB2700MQ
BiscuitLAB2700MT
PewterLAB2700ML
Stack Kit
Are you planning to stack your washer and dryer? To do so you will need to purchase a Stack Kit.
To order, call the dealer from whom you purchased your dryer or refer to the “Assistance or Service” section of this manual. Ask for Part Number 8541503.
4
