iNSTALLATiON
STEP 5: INSTALL THE MOUNTING PLATE
THE OVEN MUST BE CONNECTED TO AT
LEAST ONE WALL STUD.
1.Draw a vertical line on the wall at the center of the 30" wide space.
Use the mounting plate as the template for the rear wall. Place the mounting plate on the wall, making sure that the tabs are against the bottom of the cabinet. Line up the
notch and center line on the mounting plate to the center line on the wall.
2.While holding the mounting plate with one hand, draw circles on the wall at holes A, B, C and D. Four holes must
be used for mounting. If the holes are not used, the installation will not be secure, installer must use these
holes for proper installation. Use toggle bolts through these holes unless one of them lines up with a stud. Use a wood screw for studs.
NOTE: Draw a fifth circle inside area E, through one of the bottom holes to match the location of a stud.
For
adaptor/mounting plate for
3.Drill holes on the circles. If there is a stud, drill a 3 / 16" hole for lag screws. If there is no stud, drill a
3 / 4" hole for toggle bolts. Make sure to use at least 1 lag screw in a stud, and 4 toggle bolts in the drywall or the plaster.
4.Attach the plate to the wall. To use spring toggle heads bolts: Remove the toggle wings from the bolts. Insert the bolts into the mounting plate and replace the spring toggle
heads to 3 / 4" past the bolt ends. insert the spring toggle heads into the holes in the wall to mount the bracket. You
may pull forward on the bracket to help in tightening the toggle bolts. Tighten all bolts.
3/16" Hole on Studs 3/4" Hole on Drywall Only
Minimum 66" |
|
|
From the F oor |
|
|
/i | I | For Wall- |
| ||
| l | Vented Only |
pc.
| _ | / |
|
|
|
|
| = |
|
|
|
|
|
|
|
| |
| / |
|
| Draw Lines |
| |||
| / |
|
| on Studs |
| _ | \ | |
/ |
| Mounting |
|
|
| _ | _ | |
i |
| Plate | _ |
| Draw | _ |
| |
/ |
| / |
|
| Center | Line | _ | \ |
. |
|
| 07 | I_',_, | ,° |
| , | |
|
|
|
|
|
| ............................:t | ||
C_I |
| Center | Line | - |
| 1_i_ | S | |
o o | o | o o | o o | o o c_ o | o o o | o o o | o | o |
|
| m | [] |
| m |
|
| |
Support | Tab |
|
|
| Support | Tab |
Figure 26
Space More Than Wall Thickness
,_ggle Wings
Figure 27
18