Installation Instructions
A.Removing Mounting Plate
1.Place protective blanket on work surface to protect outer case of microwave oven. Place microwave oven on control panel side.
2.Remove 2 screws from mounting plate, as shown above. Plate will be used as rear wall template.
3.Locate separately packed grease filters and hardware packet.
4.Remove any adhesive tape on exhaust adaptor, grease filters, and power supply cord.
Outside Top Exhaust (Vertical Duct)
1.Slide exhaust adaptor to one side, squeeze sides and remove. Save damper and exhaust adaptor.
2.Proceed to "Preparing Top Cabinet".
Outside Back Exhaust (Horizontal Duct)
1.Slide exhaust adaptor to one side, squeeze sides and remove. Save damper and exhaust adaptor. See diagram above.
2.Remove and save 3 screws holding blower plate to microwave oven.
B. Preparing Microwave Exhaust Duct
This microwave oven is designed for adaptation to the following three types of ventilation.
•Outside Top Exhaust (Vertical Duct)
•Outside Back Exhaust (Horizontal Duct)
•Recirculating
Select type of ventilation required for your installation and proceed to that section.
NOTE: Microwave oven is shipped assembled for top exhaust. Adjustments will need to be made to assure proper alignment with current exhaust duct after microwave oven is installed.
3.Lift off blower plate.
4.Remove and save the screw that holds blower motor to microwave.
4