Installation Instructions

¬BEFORE USING YOUR WINE CHILLER

•Remove the exterior and interior packing.

•Check to be sure you have all of the following parts:

1 Instruction Manual

6 Large Shelves

1 Small Shelf

1 Display Rack Shelf

2 Keys

•Before connecting this appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.

•Clean the interior surface with lukewarm water using a soft cloth.

¬INSTALLATION OF YOUR WINE CHILLER

•This appliance is designed to be for free standing installation or built-in (fully recessed).

•Place your Wine Chiller on a floor that is strong enough to support it when it is fully loaded. To level your Wine Chiller, adjust the front leveling legs at the bottom of the Wine Chiller.

•Locate the Wine Chiller away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the unit not to perform properly.

•Avoid locating the unit in moist areas.

•Plug the Wine Chiller into an exclusive, properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized Avanti Products service center.

¬BUILT – IN CABINET INSTRUCTIONS

This unit is designed for both built-in or free standing installation. in application please follow the requirements shown to the right.

49 ¾”

			Figure shown →
	Unit Dimensions
		IN (min)		MM (min)
Width		23.5		597 mm
Depth		28.75		729 mm
(with handle)
Depth		26.8		681 mm
(without Handle)
Height		48.5		1232 mm

If you plan to use this unit in a built-

←Figure shown

Cabinet Opening Dimensions IN (min) MM (min)

Width 24” 610 mm

Depth 26” 661 mm

Height 49 ¾” 889 mm

Including Door and handle.