3Installation
Always have the repair procedures carried out by the Authorised Service Agent. Manufacturer shall not be held liable for damages that may arise from procedures carried out by unauthorised persons.
To make the product ready for use, make sure that the electricity installation is appropriate before calling the Authorised Service Agent. If not, call
a qualified electrician to have any necessary arrangements carried out.
C Preparation of the location and electrical installation at the place of installation is under customer's responsibility.
B Product must not be plugged in during installation. Otherwise, there is the risk of death or serious injury!
B WARNING: Manufacturer shall not be held liable for damages that may arise from procedures carried out by unauthorised persons.
A WARNING: Prior to installation, visually check if the product has any defects on it. If so, do not have it installed. Damaged products cause risks for your safety.
C Make sure that the power cable is not pinched or crushed while pushing the product into its place after installation or cleaning procedures.
3.1.Appropriate installation location
WARNING: If the door of the room where Athe product will be placed is too small for
the product to pass, then the product's doors can be removed and the product turned aside to pass it through.
•Choose a place at where you would use the product comfortably.
•Install the product at least 30 cm away from heat sources such as hobs, ovens, heater cores and stoves. Product must not be subjected to direct sun light and kept in humid places after installation.
•Appropriate air ventilation must be provided around your product in order to achieve an efficient operation. If the product is to be placed in a recess in the wall, pay attention to leave at least 5 cm distance with the ceiling and side walls.
•Do not place the product on the materials such as rugs or carpets.
•Place the product on an even floor surface to prevent jolts.
•Do not install the product in places where the temperature falls below 5°C.
C If two coolers are to be installed side by side, there should be at least 4 cm distance between them.
3.2.Installing the plastic wedges
Plastic wedges are used to create the distance for the air circulation between the product and the rear wall. Insert the 2 plastic wedges onto the rear ventilation cover as illustrated in the figure. To install the wedges, remove the screws on the product and use the screws given in the same pouch with the wedges.
Refrigerator / User Manual
7 / 30 EN