Plumbing Requirements

In order to operate the automatic ice maker/dispenser and chilled water dispenser, you will need to get your appliance plumbed into the cold mains water supply in your house via a standard 1/2 “ valve fitting. If in doubt contact a qualified plumber and your local water company. See page 9.

TRANSPORTATION INSTRUCTIONS

1.The appliance should be transported only in a vertical upright position. The packing as supplied must be intact during transportation.

2.If during the course of transport the appliance has to be transported horizontally, it must only be laid on its left hand side when standing in the front of the appliance. After bringing it to upright position,it must not be operated for at least 4 hours to allow the system to settle.

3.Failure to comply with the above instructions could result in damage occuring to the appliance. The manufacturer will not be held responsible if these instructions are disregarded.

4.The appliance must be protected against rain, moisture and other atmospheric influences.

5.When positioning your appliance take care not to damage your flooring, pipes, wall coverings etc. Do not move the appliance by pulling by the door or handle.

6.Empty any water in the drain tray before moving. See section ‘Care & cleaning’ for further information.

Do not attempt to sit or stand on top of your appliance as it is not designed for such use. You could injure yourself or damage the appliance.

IMPORTANT: Make sure that mains cable is not caught under the appliance during and after carrying / moving the appliance, to avoid the mains cable becoming cut or damaged."

Do not allow children to play with the appliance or tamper with the controls.

IMPORTANT

INSTALLATION INSTRUCTIONS

1.The space in the room where the appliance is installed must not be smaller than 10 cubic metres.

2.Do not put your fridge freezer in a cold room where the temperature is likely to go below +5 degrees C (41 degrees F) during night time and/or especially in winter.

This fridge freezer has been designed to operate in ambient temperatures between +5 and +32 degrees C (41 and 90 degrees F) Therefore if the appliance is installed in an unheated/cold room (eg: conservatory/annex/ shed/garage etc) then the appliance will not operate causing the freezer compartment to run warmer and as a result the storage time of frozen food may be reduced.

3.Do not place the appliance near cookers, radiators or in direct sunlight as this will cause your appliance to work harder. If installed next to a source of heat or freezer, maintain the following minimum side clearances:

From Cookers	50 mm (2")

From Radiators	300 mm (12")

From Freezers	25 mm (1")

From Wall	50 mm (2")

4.Adjustable feet adjustment for levelling

If your refrigerator is not level, you can level it by turning the front feet as illustrated in the figure below. The corner where the feet is lowered when you turn in the direction of black arrow and raised when you turn in the opposite direction. You may need somebody to help you to slightly lift the refrigerator off the floor for a few centimeters. Take care when lifting the appliance because it is very heavy.

5. Door height adjustment

If there is a misalignment between the doors, perform the steps indicated below to adjust door heights:

Doors can be raised vertically. This process can be performed easily using a flat tipped screwdriver and an allen key (M6) as illustrated in the following figures. Door racks should be removed when adjusting the door height.

•Remove the screws fastening the lower cover using a flat tipped screwdriver in the order shown in the figure.

1 2 3