•First Check that the following items are supplied with appliance.
1.
2.Nut for connection of the water pipe to the rear of the appliance
3.Cold mains water valve with mesh filter
4.3 pieces of pipe clips (In case required to secure the water pipe)
5.Water Filter to be fitted to the bracket inside the fridge compartment.
Water Tube | Water Tube | |
Nut | ||
|
2 
1
1
3
4
Connecting the water pipe to the cold mains water supply
1.Separate the nut from the valve adaptor.
2.Connect the valve adaptor to the Feed Valve as shown in the figure.
3.Connect the water pipe to the valve adaptor and offer the nut to the valve adaptor as shown in the figure.
4.Tighten the nut manually. In case of a leak use a spanner or a pair of pliers to tighten the nut.
Mesh |
|
| |
Filter |
| Main | |
|
| Cold Water Line | |
Tap |
|
| |
Adaptor |
| Tap | |
| Feed | ||
| Adaptor | ||
Nut | Valve | ||
| |||
|
|
5
2
Figure 1 | Figure 2 |
|
Connection to the Cold Mains Water Valve
Please follow the instructions below
MAKE SURE THAT STANDARD 1/2” VALVE FITTING FED BY COLD MAINS WATER SUPPLY IS AVAILABLE AND IS TURNED OFF FULLY.
Connection of the water pipe to the refrigerator
1.Connect the water pipe to the inlet at the rear of the appliance as shown in the figure below.
2.Fix the nut to the valve as shown in the figure.
3.First offer the nut to the water pipe. Then push water pipe down firmly in to the inlet fitting. Then tighten the nut manually. You should not need to tighten the nut with a tool to achieve water tight assembly. In case of a leak use a spanner or a pair of pliers to tighten the nut.
8
Tap
Adaptor
Nut
Water Pipe
Figure 3
Secure the
Warning: After turning on the water valve, make sure that there is no leakage at both connection points of the water pipe. In case of a leak, turn off the valve immediately and tighten all joints again using a spanner or a pair of pliers.
9