O PERATING SEQUENCE
1. Load the dishes.
Remove any scraps of food in advance. Pull the lower rack out and load the dishes and cutlery in and push it all the way back. Pull the upper rack out and load the cups, glasses, etc.
2. Turn on the dishwasher.
When ready to run a cycle, open the door and press the power button. The dishwasher defaults to the normal cycle.
6.Close the door. The dishwasher starts automatically after a slight delay.
7.At the end of the Program.
End is displayed on the digital display for a few seconds and a tone will sound, signaling program completion. The dishwasher automatically switches off for safety and energy savings.
OPERATING SEQUENCE
3. Check rinse-aid.
The indicator lights will illuminate if the rinse aid level is low.
NOTE
The estimated remaining time will be displayed. If the door is opened during operation, the dishwasher stops. Once the door is closed, the program will restart from the point where it stopped.
4. Measure the detergent.
Add the required amount of detergent into the dispenser. Close the detergent dispenser lid.
5. Setting the program.
Select desired program and options.
Before starting, the display window will show the estimated running time of the selected program. If the number of dishes fills only one rack, you can use the Half Load option. For example, if you load dishes only on the upper rack, you adjust the Half Load button to the upper rack.
Remember to load all dishes into the selected rack.
The estimated remaining time will be displayed.
If the door is opened during operation, the dishwasher stops.
Once the door is closed, the program will restart from the point where it stopped.
Caution
Empty the lower rack first and then the upper one, this will avoid water dripping from the upper rack onto the dishes in the lower one.
Warning
In general,it is not advisable to open the door while the dishwasher is running. If the door is opened, a safety device stops the machine.
Care should be taken when opening the door immediately following the cycle, as steam may escape.
Auto-Off
When the power is turned on, if you don’t select program or if you don’t close the door after selecting a program, your dishwasher will automatically turn off in 10 minutes.
Dual IntensityTM Wash Cycle
Course Selection � Press SPRAY key for 3 sec. � SPRAY selection for upper spray (Strong/Medium/soft/off) � Press HALF LOAD to select lower rack � SPRAY selection for lower spray(Strong/Medium/soft/off) � Check selection by press HALF LOAD � Another option � Door Closed � Start
16