Sennheiser EK3253 Using the receiver, Switching the receiver on/off, Connecting the headphones

Page 13

Using the receiver

Switching the receiver on/off

To switch the receiver on, turn the volume control to the right until it clicks. The red LED lights up.

To switch the receiver off, turn the volume control to the left until it clicks. The red LED goes off.

Note:

yThe receiver has a short switch-on delay.

yRemove the batteries or the accupack when the receiver will not be used for extended periods of time.

Connecting the headphones

Attention! High volume!

Even short exposure to high volume levels can damage your hearing! Set the volume for the connected headphones to the minimum before putting the headphones on. Do not listen at higher volume levels than with loudspeakers.

15

Image 13

Contents Instructions for use Contents Thank you for choosing Sennheiser Health risks arising from use Safety instructionsIntended use of the receiver Delivery includesImproper use Channel bank system EK 3253 bodypack receiverRecommended transmitters UP/DOWN Operating controlsIndications and displays Operation and battery status indicationLC display Mute display Modulation display of the received transmitterPilot display RF signal indicationDisplay backlighting Inserting and replacing the batteries Preparing the receiver for useInserting and charging the accupack Switching the receiver on/off Using the receiverConnecting the headphones Adjusting the volume Activating/deactivating the lock mode Adjusting the balance/FOCUSAttaching the receiver to clothing Buttons Operating menuOverview of menus Getting into the operating menu Working with the operating menuSelecting a menu Storing a setting Adjusting a settingExiting the operating menu Exit Operating menu of the receiverChan Selecting a channel Chan Adjustment tips for the operating menuScanning the channel bank for free channels Adjusting the squelch threshold SqelchStarting the scan and storing the scan result Releasing locked channelsImportant note HI-BST Stereo/FOCUS selection ST-FOCEntering a name Name Selecting the standard display DislpyActivating/deactivating the lock mode Lock Loading the factory-preset default settingsActivating/deactivating the pilot tone evaluation Pilot Exiting the operating menu Exit Error checklist If problems occurRecommendations and tips Maintenance and careFor the receiver For optimum receptionAdditional information Pilot tone squelch SquelchField strength-dependent squelch EK 3253 bodypack receiver SpecificationsAccessories Connector assignmentWarranty regulations