TEST THE LATCH AND SWITCH SEQUENCE
(5)Open the oven door slowly. Watch the door latch, the Secondary Switch. Release Rod and Lever on the switches to make sure they are zero to the body of the switches in the following sequence:
-Primary Interlock Switch
-Secondary Interlock Switch
-Interlock Monitor Switch
Adjust the latch board until the switches operate in this sequence. See Steps 3 and 4.
(6)Close the oven door slowly and be sure it is tightly closed. Watch the three switches to make sure they are zero to the body of the switches in the following sequence:
-Interlock Monitor Switch
-Primary Interlock Switch
-Secondary Interlock Switch
NOTE: The Interlock Monitor Switch is an added
safety check on the Primary and Secondary Interlock Switches. If the Primary and Secondary Interlock Switches allow the oven to operate with the door open, the Monitor Switch will blow the fuse.
(7)When you achieve the proper sequence of switches in Steps 5 and 6, tighten the latch board screws at that point.
TEST THE MICROWAVE ENERGY LEAKAGE
Make sure the microwave energy leakage is below the limit of 1mW/cm2 (with a 275 ml water load) and 5mW/cm2 (with a 275 ml water load without the cabinet) when measured with a survey meter.