CHARCOAL FILTER | COOKTOP/NIGHT LIGHT | ||||
REPLACEMENT | REPLACEMENT | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
To avoid risk of personal injury or property damage, do not operate oven hood without filters in place.
If your microwave hood combination is installed to recirculate air, the charcoal filter (5230W1A003C) is available by calling the Parts department at your nearest Authorized Service Center. The charcoal filter cannot be cleaned and should be replaced every
1. Unplug microwave oven or disconnect power.
2. Open the door and remove the one vent grille mounting screw. (1 middle screws)
PUSH
3. Slide the grille left and tip forward, then lift out to remove.
4. Remove old filter.
5. Slide a new charcoal filter into place. The filter should rest at the angle shown.
6. Slide the bottom of the grille into place. Push the top and slide right until it snaps into place. Replace the mounting screws. Turn the power back on at the main power supply and set the clock.
To avoid personal injury or property damage, wear gloves when replacing light bulb.
1. Unplug microwave oven or disconnect power.
PUSH
2. Remove the lamp cover mounting screws.
3. Replace bulb(s) with 20~40 watt appliance bulb(s).
4. Replace lamp cover, and mounting screws.
5. Plug in microwave oven or reconnect power.
OVEN AND WARMING LAMP LIGHT REPLACEMENT
1. Unplug microwave oven or disconnect power.
2. Open the door and remove the vent grille mounting screw.
3. Slide the grille left and tip the cover forward, then lift out to remove. 
PUSH
4. Remove the bulb holder mounting screw, and lift up the bulb holder which you want to replace.
OVEN LIGHT WARMING LAMP LIGHT
5.Replace bulb with a 30 watt appliance bulb.
6.Replace the bulb holder, if damaged.
7.Slide the bottom of the vent cover into place. Push the top and slide right until it snaps into place. Replace the mounting screws. Plug in microwave
oven or reconnect power.
27