Before You Call For Service
If you are having an operating problem, check the chart to see what the cause might be before you call for assistance.
OPERATING PROBLEM Nothing operates.
Oven will not operate.
Burner fails to light.
Burner flames are uneven.
Burner flames lift off ports, are yellow, or are noisy when turned off.
Burner makes popping noise when on.
CHECK IF
. Range is properly connected to gas and electrical supplies.
. Fuse has blown or circuit breaker has tripped.
mControl knob is set in the correct position.
. The flow of combustion and/or ventilation air to the range is blocked.
1The Oven Selector is turned to BAKE or BROIL.
1The Oven Temperature Control is turned to a temperature setting.
l The Cook Timer is set correctly.
. Range is connected to electrical power.
1Fuse has blown or circuit breaker has tripped.
mBurner ports are clogged.
. Burner ports are clogged.
1Burner is wet from washing.
WHAT TO DO
1 Contact an authorized RoperSMservice technician to reconnect range to gas and/or electrical supply. (See Installation Instructions.)
1 Replace fuse or reset circuit breaker. In case of prolonged power failure, manually light burners (see page 4).
mSet control knob correctly. if needed.
. Remove blockage to air flow to and around range.
. If needed, set Oven Selector to BAKE or BROIL. If Oven Selector is turned to TIMED BAKE, wait until the start time is reached.
mIf needed, turn the Oven Temperature Control to a temperature setting.
mSee page 6 for instructions on how to set the Cook Timer.
. Contact an authorized RoperSMservice technician to reconnect range to electrical supply. (See Installation Instructions.)
. Replace fuse or reset circuit breaker. In case of prolonged power failure, manually light burners (see page 4).
mClean with a straight pin (see pages 8 and 11).
1Clean with a straight pin (see pages 8 and 11) If this fails, call an authorized
. Contact an authorized RoperSMservice techni- cian to check air/gas mixture.
ILet dry. I1
Continued on next page
Page 13