Using Your Range

Oven indicator Left front Electronic clocWTv¶inute Surface burner Clean indicator

Setting the electronic clock

The electronic clock is a digital clock with a Minute Timer and automatic control cooking cycle. Time-of-day, Minute Timer times and cook times are set by pushing command buttons on either side of the display.

Oven I	ieft rear control
temperature control	knob

Using the surface burners

Push Fn

andtum

Control knobs must be pushed in, then turned to the LlTE position. The clicking sound is the ignition sparlang.

To stop the clicking sound after the burner lights, turn the control lmob back to a desired setting. The control knob can be set anywhere between HI and OFF.

Surface burner markers

The solid dot in the surface burner marker shows which surface burner is turned on by that knob.

Until you get used to the settings, use the following as a guide. For best results, start cooking at the high settings, then turn the control knob down to continue cooking.

Use LITE to light the burner. After the burner lights. turn control back to a desired setting to stop the clicking of the ignition.

Use a high setting to start food cooking; to bring liquids to a boil.

Use a medium setting to continue cooking or to fry chicken or pancakes; for gravy, puddings and icing; to cook large amounts of vegetables.

Use a low setting to keep food warm until ready to serve.

NOTE: DOnot cook with the control in the LlTE position.

Hold a lit match near a burner and- slowly turn the control knob on until the burner lights. After the burner lights, turn the control knob to the desired setting.

Bum, Fire And Explosion Hazard

. Burner flame should not extend beyond the edge of the cooking utensil. The flame can bum you and cause poor cooking retits.

. Be sure all control knobs are turned to OFF when you are not cooking. Someone could be burned or a fire could start if a burner is accidentally left ON.

. If the flame should go out while cooking, or if there is a strong gas odor, turn the burners OFF. Wait five minutes for the gas odor to disappear, before relighting burner. If gas odor is still present, see safety note on page 2. Failure to follow these precautions could result in explosion or fire.

-Do not attempt to light the oven burner during a power failure. Personal injury could result.

1.When the range is connected to power, or a power failure longer than three seconds occurs, “i2:OO” will flash on the display.

2.Push the Cancel/Clock button.

3.Set the desired time by pushing the Up and Down buttons. The time will increase or decrease on the display, depending upon which button you push. “PM” will appear on the display for a PM time setting.

Setting the electronic Minute Timer

The Minute Timer does not start or stop the oven. It works like a kitchen timer. It can be set in hours and minutes up to 9 hours 59 minutes. When the set time is up. you will hear a l/2-second on and l/2-second off tone and the lower dot in the middle of the display will flash. Press the Minute Timer button to cancel the tone and flashing dot.

l.IPush the Minute Timer button.

2.Set the desired time by pushing the Up and Down buttons. The time will increase or decrease on the display, depending upon which button you push. The lower dot in the middle of the display will light up, indicating that the Minute Timer is on.

3.The display will show the set time, then return to time-of-day.

4.To see the remaining set time before the set time is up, press the Minute Timer button.

To cancel the Minute Timer:

Push the Minute Timer button, followed by the Up or Down buttons until “0:OO” shows on the display.

Page 4