LG Electronics LFC25760 Using Your Refrigerator, Ensuring Proper AIR Circulation, Multi-Flow

Page 16

USING YOUR REFRIGERATOR

ENSURING PROPER AIR CIRCULATION

In order to ensure proper temperatures, air must flow between the refrigerator and freezer sections. As shown in the illustration below, air enters at top of the freezer and circulates down. From the bottom of the freezer, air is forced up to the top of the refrigerator. Air enters refrigerator through the top vent, then circulates and exists at the bottom, where it returns to the freezer.

MULTI-FLOW

•Multi-Flow means powerful and effective cooling operation. This is especially noticeable when new food is placed in the refrigerator compartment.

•If water or foreign substances enter the cool air vent while cleaning, efficiency will be lowered. In addition, if gasket is damaged, efficiency may be lowered because of escaping cool air.

Do not block any of cool air vents with food packages. If the vents are blocked, airflow will be interrupted and temperature and moisture problems may occur.

IMPORTANT: Because air circulates between both sections, any odors formed in one section will transfer to the other. You must thoroughly clean both sections to eliminate odors. To prevent odor transfer and drying out of food, wrap or cover foods tightly. (See the Food Storage Guide section for details.)

SETTING THE CONTROLS

•Your refrigerator has two controls that let you regulate the temperature in the freezer and refrigerator compartments.

•Initially set the REFRIGERATOR CONTROL at 37°F (3°C) and the FREEZER CONTROL at 0°F (–18°C). Leave it at this setting for 24 hours (one day) to stabilize. Then adjust the compartment temperature as desired.

•Refrigerator control: 33°F to 46°F (0°C to 8°C)

The lower the number setting, the colder the refrigerator compartment will become.

•Freezer control: –6°F to 8°F (–21°C to –13°C) When the setting is at a lower number, the freezer compartment becomes colder. But the refrigerator compartment becomes warmer because less cold air flows into the refrigerator.

•ICE PLUS:

Press the ICE PLUS key and the LED will turn on. This function will remain activated for 24 hours and intensify the cooling speed of freezer and increase the amount of ice.

NOTE: If you want to change °F to °C, press and hold COLDER key of freezer and COLDER key of refrigerator over 5 seconds at the same time. and if you want to change °C to °F, hold them for 5 seconds again.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Congelador Inferior Refrigerador Table of Contents LG ELECTRONICS, INC LG Refrigerator Limited Warranty USA Authorized Service Center. Phones are answeredPlease call 1-800-243-0000 and choose Appropriate option to locate your nearest LGLimited Warranty Canada LG Refrigerator Read all instructions before using this appliance Safety MessagesDo not modify or extend the power Cord length CFC Disposal Grounding RequirementsTo Connect Electricity Recommended Grounding MethodParts and Features Refrigerator Installation InstallationUnpacking Your Refrigerator NextRemoving Refrigerator Handle HOW to Remove Door HandlesRemoving Freezer Drawer Handle HOW to Replace Door Handles Replacing Refrigerator Door HandleReplacing Freezer Drawer Handle Screws Mounted On doorHOW to Remove Refrigerator Door Removing Refrigerator DoorLeft Door Right DoorReplacing Refrigerator Door Right Door HOW to Remove and Install the Pullout Drawer Removing Pullout DrawerInstalling Pullout Drawer Leveling Leveling and Door AlignmentDoor Alignment Using Your Refrigerator Setting the ControlsEnsuring Proper AIR Circulation MULTI-FLOWAdjusting Control Settings Food Storage GuideStoring Frozen Food PackagingPackaging recommendations Do not useAdjusting Shelves Refrigerator ShelvesBottle Holder Sliding Out ShelvesCrisper Humidity Control Optibin CrispersRemoving Crisper Crisper Cover with Lattice on Inner Surface To remove the crisper door flapTo remove the glass To remove the lattice on inner surfaceGLIDE‘N’SERVE Modular Door BINCold Temp Control Colder Controls To remove Glide‘N’ServeICE BIN Dairy BINEGG BOX Durabase Divider DurabasePull OUT Drawer Care and Cleaning Power Interruptions When YOU GO on VacationWhen YOU Move To change freezer lightWhen YOU should SET the Icemaker Power Switch to O OFF About the Automatic IcemakerOperation Instructions Normal Sounds YOU MAY HearConnecting the Water Line Fasten the Shutoff Valve Connect the Tubing to the ValveTighten the Pipe Clamp Flush OUT the TubingConnect the Tubing to the Refrigerator Turn the Water on AT the Shutoff ValvePlug in the Refrigerator Start the IcemakerTroubleshooting Guide Refer to the Setting the Controls sectionUnderstanding Sounds YOU MAY Hear Check if… Then…See the Adjusting Control Settings section Completely belowSee Leveling and Door Alignment on Door Alignment section onRefer to the Understanding Sounds You Production. See the Setting the ControlsMay Hear section on See Doors will not close completely on Memo
Top Page Image Contents