LG Electronics LFC25760 manual Crisper Cover with Lattice on Inner Surface, To remove the glass

Page 21

USING YOUR REFRIGERATOR

To remove the crisper door flap

1.Raise the door flap as high as it will open.

2.Press the plastic hinge toward the center of the door flap with your finger.

3.Lift the door out of its place.

4.To replace, reverse the above procedure.

To remove the glass

1.Lift up the glass after inserting a finger into a hole under the crisper cover.

2.Pull the glass up and out.

CRISPER COVER WITH LATTICE ON INNER SURFACE

To remove the lattice on inner surface

1.Remove the crisper cover (as illustrated above).

2.Hold the glass cover and turn the crisper cover over.

3.For each lattice, hold the lattice and pull the side of the cover outward to remove it.

To replace lattice on inner surface

1.For each lattice, insert the lattice into middle tab in 1 (closed to glass cover) and pull the side of the cover to

insert it.

2 3

Image 21

Contents Congelador Inferior Refrigerador Table of Contents Authorized Service Center. Phones are answered LG ELECTRONICS, INC LG Refrigerator Limited Warranty USAPlease call 1-800-243-0000 and choose Appropriate option to locate your nearest LGLimited Warranty Canada LG Refrigerator Safety Messages Read all instructions before using this applianceDo not modify or extend the power Cord length Grounding Requirements CFC DisposalTo Connect Electricity Recommended Grounding MethodParts and Features Installation Refrigerator InstallationUnpacking Your Refrigerator NextHOW to Remove Door Handles Removing Refrigerator HandleRemoving Freezer Drawer Handle Replacing Refrigerator Door Handle HOW to Replace Door HandlesReplacing Freezer Drawer Handle Screws Mounted On doorRemoving Refrigerator Door HOW to Remove Refrigerator DoorLeft Door Right DoorReplacing Refrigerator Door Right Door Removing Pullout Drawer HOW to Remove and Install the Pullout DrawerInstalling Pullout Drawer Leveling and Door Alignment LevelingDoor Alignment Setting the Controls Using Your RefrigeratorEnsuring Proper AIR Circulation MULTI-FLOWFood Storage Guide Adjusting Control SettingsPackaging Storing Frozen FoodPackaging recommendations Do not useRefrigerator Shelves Adjusting ShelvesBottle Holder Sliding Out ShelvesOptibin Crispers Crisper Humidity ControlRemoving Crisper To remove the crisper door flap Crisper Cover with Lattice on Inner SurfaceTo remove the glass To remove the lattice on inner surfaceModular Door BIN GLIDE‘N’SERVECold Temp Control Colder Controls To remove Glide‘N’ServeDairy BIN ICE BINEGG BOX Durabase Durabase DividerPull OUT Drawer Care and Cleaning When YOU GO on Vacation Power InterruptionsWhen YOU Move To change freezer lightAbout the Automatic Icemaker When YOU should SET the Icemaker Power Switch to O OFFOperation Instructions Normal Sounds YOU MAY HearConnecting the Water Line Connect the Tubing to the Valve Fasten the Shutoff ValveTighten the Pipe Clamp Flush OUT the TubingTurn the Water on AT the Shutoff Valve Connect the Tubing to the RefrigeratorPlug in the Refrigerator Start the IcemakerRefer to the Setting the Controls section Troubleshooting GuideUnderstanding Sounds YOU MAY Hear Check if… Then…Completely below See the Adjusting Control Settings sectionSee Leveling and Door Alignment on Door Alignment section onProduction. See the Setting the Controls Refer to the Understanding Sounds YouMay Hear section on See Doors will not close completely on Memo