CONNECTING THE WATER LINE
9.CONNECT THE TUBING TO THE REFRIGERATOR
Removing and Replacing Valve Cover
NOTE:
•Before making the connection to the refrigerator, be sure the refrigerator power cord is not plugged into the wall outlet.
1.Remove the plastic flexible cap from the water valve.
2.Place the compression nut and ferrule (sleeve) onto the end of the tubing as shown.
3.lnsert the end of the copper tubing into the connection as far as possible. While holding the tubing, tighten the fitting.
wCAUTION: Check to see if water dripping occurs at water line connections.
10.TURN THE WATER ON AT THE SHUTOFF VALVE
Tighten any connections that leak.
Reattach the compressor compartment access cover.
11. PLUG IN THE REFRIGERATOR
Tubing Clamp
1/4 " Compression Nut
Ferrule (sleeve)
1/4 " Tubing
Refrigerator
Connection
Arrange the coil of tubing so that it does not vibrate against the back of the refrigerator or against the wall. Push the refrigerator back to the wall.
12. START THE ICEMAKER
Set the icemaker power switch to the ON position. The icemaker will not begin to operate until it reaches its operating temperature of 15°F
30