Liebherr HC 1011/1060 HC 1001/1050 121113 7082698 - 00 General safety information, Energy saving

Page 4

General safety information

1.5 Energy saving

- Always ensure good ventilation. Do not obstruct venti- lation openings or grilles.

- Do not install the appliance in direct sunlight or next to an oven, heater, or similar heat source.

- Energy consumption depends on installation conditions such as the ambient temperature (see 1.3) .

- Avoid opening the appliance door for any longer then neccesary.

- The lower the temperature is set the higher the energy consumption.

- All food stored in the appliance should be well wrapped and covered. This prevents frost buildup.

- Only take food out for as long as necessary so that it does not get too warm.

- Storing hot food: let it cool to room temperature first. - Defrost frozen food in the fridge.

2 General safety information

Read and follow these instructions. They contain safety advice which is important for safe and problem-free installation and operation. Always read and follow the safety advice.

Dangers for the user:

-This appliance can be operated by children 8 years and older as well as by persons with reduced physical, sensory or mental capabili- ties or lack of experience and knowledge if they are supervised or have been instructed in the safe use of the appliance and understand the associated risks. Children must not play with the appliance. Cleaning and user mainte- nance must not be performed by children unless they are supervised.

-When disconnecting the appliance from the outlet, always take hold of the plug. Do not pull on the cable.

-Disconnect the power plug or switch off the power if a fault occurs.

-Do not damage the mains power line. Do not operate the appliance from a defective mains power line.

-Repairs, work on the appliance and replace- ment of the power cord should only be carried out by the customer service department.

-Only install, connect and dispose of the appli- ance in accordance with the instructions.

-Only operate the appliance after it has been installed.

-Please keep the instructions and pass them on to any future owner.

-All repairs to or work on the IceMaker must only be carried out by the customer service department or other specialist engineers trained to do this.*

-The manufacturer is not liable for damage arising from incorrect connection to the water supply.*

Risk of fire:

-Do not operate the appliance near explosive gases.

-Do not store explosive materials or spray cans with flammable propellants, such as e.g. butane, propane, pentane, etc. in the appli- ance. You can recognize such spray cans by the printed contents or a flame symbol. Any leaking gasses can be ignited by electrical components.

-Alcoholic beverages or other containers holding alcohol must always be tightly sealed for storage purposes. Any leaking alcohol can be ignited by electrical components

Tipover hazard:

-Do not stand or climb on the base, drawers, doors, etc. This applies in particular to chil- dren.

Risk of food poisoning:

-Do not consume food that has passed its best before date.

Danger of frostbite, feelings of numbness and pain:

-Avoid continued skin contact with the cold surfaces or chilled/frozen food or adopt protec- tive measures, e. g. use gloves. Do not consume ice cream (especially sherbets) and ice cubes immediately when they are too cold.

Risk of injury and damage:

-Hot steam may lead to injuries. Do not use any electrical heating or steam cleaning equip- ment, naked flames or defrosting sprays for defrosting

-Do not remove ice with sharp objects

Follow the specific instructions in the other sections:

 

DANGER

indicates a hazardous situation,

 

 

which if not avoided, will result in

 

 

death or serious injury.

 

WARNING

indicates a hazardous situation,

 

 

which if not avoided, could result in

 

 

death or serious injury.

 

 

 

4

* Depending on model and options

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Use and Care Manual Appliance at a glance Contents Appliance at a glanceInstructions for testing institutes OverviewRange of appliance use ConformityGeneral safety information Energy savingControls and displays Start-upConnecting the appliance Disposal of packagingSwitching on the appliance Temperature display unitBrightness of the temperature display OperationTemperature alarm Door alarmFridge compartment Setting the temperature Using the split shelfSuperCool 5 FanFreezer compartment SuperFrost DrawersVarioSpace Info systemCleaning the appliance MaintenanceDefrosting with NoFrost Cleaning the IceMaker Customer serviceAfter cleaning Replacing the interior lightTroubleshooting Appliance InformationProblem Possible Cause Correction Faint clicking Switches onMechanism Temperature Cates F0 to F5 TemperatureProblem Possible Cause Correction Is not coldEnough Display showLiebherr Warranty Plan Putting appliance out of serviceDisposing of the appliance Terms Applicable to Each Warranty Liebherr Warranty Plan For Service in the U.S Liebherr Service Center For Service in CanadaToll Free 1-866-LIEBHER or Toll Free 1-888-LIEBHER or

HC 1011/1060 HC 1001/1050 121113 7082698 - 00 specifications

The Liebherr HC 1011/1060 and HC 1001/1050 are part of the esteemed Liebherr line of high-performance hoists and cranes. These models are designed specifically for heavy lifting and material transport in various industrial applications. Liebherr is widely recognized for its commitment to innovation and reliability, and the HC series exemplifies this dedication.

One of the main features of the HC 1011/1060 and HC 1001/1050 is their impressive lifting capacity. These cranes can handle significant loads, making them ideal for construction sites and heavy-duty operations. Their robust design ensures they can withstand harsh working conditions while maintaining safety and performance quality.

The HC series incorporates advanced technologies aimed at enhancing efficiency and user experience. For instance, Liebherr has integrated modern control systems that offer precise load management, ensuring optimal performance during operation. These control systems are user-friendly and can be easily navigated, allowing operators to efficiently manage lifting operations with greater confidence.

Safety is paramount in the design of the HC 1011/1060 and HC 1001/1050. The models are equipped with state-of-the-art safety features, including overload protection and advanced monitoring systems that alert operators to potential issues before they become significant problems. This focus on safety not only protects the equipment but also ensures the welfare of the operators and the surrounding workforce.

Durability is another characteristic that sets Liebherr's HC series apart. Constructed with high-quality materials, the HC 1011/1060 and HC 1001/1050 are designed to endure the rigors of continuous use in demanding environments. This durability translates to reduced maintenance costs and extended lifespans for the equipment, providing significant value to users.

In terms of versatility, these cranes can be adapted for various applications. Whether used in construction, shipping, or industrial manufacturing, the HC series can be configured to meet the specific needs of any project. Their compact design allows for easy maneuverability in tight spaces, enhancing their functionality across different sites.

The Liebherr HC 1011/1060 and HC 1001/1050 cranes are not just machines; they embody the company's ethos of quality, innovation, and reliability. Their cutting-edge technologies, robust safety features, and exceptional lifting capabilities make them essential equipment for any heavy-duty lifting task. As industries continue to evolve, Liebherr remains at the forefront, providing solutions that meet the demands of modern construction and heavy lifting.
Top Page Image Contents