IceMaker

4.Push the appliance slowly to the back wall until the compressor mounting plate makes contact with the anti-tipping bracket (Figure 15).

To prevent the appliance from tipping forward the compressor mounting plate must have contact with the anti tipping bracket (Figure 15).

Wall

Appliance

Anti - tipping bracket

Compressor mounting plate

Figure 15

5.Remove the cover from the valve connector (Figure 16).

6.The water line is visible at the front of the aplliance. Connect the water line with the OD adapter (Figure 16).

7.Bleed the air from the water line by opening the water supply temporarily.

8.Screw the OD adapter onto the solenoid valve (Figure 17).

Figure 16

Figure 17

9.Open the shut-off valve for the water supply and check the entire water system for leaks.

IMPORTANT

After starting up the appliance, the water pipe system must be purged of any air. Refer

to chapter "Bleeding the ice maker" in the operating instructions.