Liebherr HC1050, HC1001 installation manual Construction of Kitchen Cabinet Figure, Ure

INSTALLATION

2.Ventilation through the cabinet base at the bottom can be achieved by installing the provided ventilation grille (Fig. 6, 3) or via a ventilation opening of at least 31 in.2 (200 cm2).

When using the provided ventilation grille (Fig. 6, 3), please proceed as follows:

●In the cabinet base, cut out a ventilation opening that is 17-23/32 in. (450 mm) in width and 2-7/32 in. (56 mm) in height (Figure 6).

●Insert ventilation (Fig. 6, 3) grille into the cabinet base cut-out (Fig. 6, 1).

●From the back side, slide the snap-fits (Fig. 6, 2) into the grille until the hooks make contact with the cabinet base.

Construction of Kitchen Cabinet - Figure 7

Construct the kitchen cabinet using the dimensions shown in Figure 7.

1.Align the kitchen cabinet with a level (Fig. 7, 2) and a square. If necessary, shim underneath the cabinet to make it level. The floor and side walls must be at right angles to each other.

2.Install the refrigerator-freezer in stable kitchen cabinets only.

3.The joint between the upper and the lower kitchen cabinet door must align with the joint between the upper and lower refrigerator-freezer door.

If you use a pre-designed kitchen cabinet, you may need to shim the refrigerator-freezer so the doors are properly aligned.

●Completely mount cabinet base (with ventilation grille and snap-fits) to kitchen cabinet.

		2	4xR
					7/32
			(5			in.
1			.	mm)
			in
			-23/32
			17
2-7/32in.	(56mm)		(450mm)			3
			Fi
			ure

Figure 6

Follow the dimensions provided in Figure 7 to determine if any shims (Fig. 7, 4) are required. Also make sure you adjust the height of the kitchen cabinet (Fig. 7, Dimension “D”) if you need to add any shims.

4.Use a fish line (Fig. 7, 1) to pull the plug up to reach the outlet (Fig. 7, 3).

A delight in freshness

HC 1001 / HC 1050 7