Putting into operation
4.4 Insertion into a row of kitchen units
(1) | Stack cabinet | (3) | Kitchen cabinet Fig. 9 |
(2) | Appliance | (4) | Wall |
xFor appliances supplied with wall spacers, the measurement increases by 35 mm (see 4.2) .
The appliance can be inserted into a row of kitchen units. To match the appliance Fig. 9 (2) to the height of the row of units, a suitable stack cabinet Fig. 9 (1) can be fitted above the appli- ance.
When installing with kitchen units (max. depth 580 mm), the appliance can be positioned directly next to the kitchen cabinet Fig. 9 (3). The appliance will project by 34 mmx at the sides and 50 mmx in the centre of the appliance in relation to the kitchen cabinet front.
Ventilation requirements:
-At the back of the stack cabinet there has to be a ventilation duct of at least 50 mm depth throughout the width of the stack cabinet.
-The ventilation space under the ceiling has to be at least 300 cm2.
-the larger the ventilation space, the more
If the appliance is installed with the hinges next to a wall Fig. 9 (4), the distance between appliance and wall has to be at least 40 mm. This corresponds to the projection of the handle when the door is open.
4.5 Disposing of packaging
WARNING
Danger of suffocation due to packing material and plastic film! u Do not allow children to play with packing material.
The packaging is made of recyclable materials:
-corrugated board/cardboard
-expanded polystyrene parts
-polythene bags and sheets
-polypropylene straps
-nailed wooden frame with polyethylene panel*
uTake the packaging material to an official collecting point.
4.6 Connecting the appliance
NOTICE
Risk of damage to the electronic control system!
u Do not use
WARNING
Fire and overheating hazard!
u Do not use extension cables or multiple socket outlets.
The type of current (alternating current) and voltage at the installation site have to conform with the data on the type plate (see Appliance at a glance).
The socket must be properly earthed and fused. The tripping current for the fuse must be between 10 A and 16 A.
The socket must be easily accessible so that the appliance can be quickly disconnected from the supply in an emergency. It must be outside the area of the rear of the appliance.
u Check the electrical connection. u Plug in the power plug.
4.7 Switching on the appliance
Note
u To switch on the entire appliance it is necessary only to switch on the freezer compartment. In so doing, the refriger- ator compartment is automatically switched on as well.
Put the appliance into operation about 2 hours before first loading food to be frozen.
4.7.1 Switching on the freezer compartment
uPressOn/Off button, freezer compartment Fig. 3 (9).
The appliance is switched on. The refrigerator compartment temperature display indicates the set temperature. The freezer compartment temperature display and the alarm button flash until the temperature is sufficiently low.
If all LEDs in the display light up, demo mode is activated.
Please contact the after sales service.ww
4.7.2Switching on the refrigerator compart-
ment
Note
u When the refrigerator compartment is switched on, the
freezer compartment is automatically switched on as well.
uPress On/Off button, refrigerator compartment Fig. 3 (1). w The interior light is on when the door is open.
w The temperature display shines. Refrigerator compartment and freezer compartment are switched on.
8 | * Depending on model and options |