Putting into operation
u In the case of an appliance with enclosed wall spacers, mount the wall spacers on the back of the appliance at the top left and right.
uDispose of packaging material (see 4.5) .
uAlign the appliance so that it stands firmly and on a level by applying the accompanying spanner to the adjustable- height feet (A) and using a spirit level.
uThen support the door: Extend the adjustable foot at the turn hinge (B) until it rests on the floor and then make a further 90° turn.
Note
u Clean the appliance (see 6.2) .
If the appliance is installed in a very damp environment, condensate may form on the outside of the appliance.
u Always see to good ventilation at the installation site.
4.3 Changing over the door hinges
You can change over the door hinges if necessary. Ensure that the following tools are to hand:
q Torx® 25
q Torx® 15 q Screwdriver
q Cordless screwdriver, if necessary
q Second person for fitting work, if needed
4.3.1 Detaching the upper door
Note
u Remove any food from the door racks before removing the door, so that no food falls out.
Fig. 4
u Close the upper door.
u Pull off the cover Fig. 4 (1) forwards and upwards. u Lift off the cover Fig. 4 (2).
CAUTION
Risk of injury if the door tips! u Take good hold of the door. u Set down the door carefully.
u Unscrew the upper turn hinge Fig. 4 (3)(2x Torx® 25) Fig. 4 (4) and lift it off.
u Lift up the upper door and set it aside.
4.3.2 Detaching the lower door
uClose the lower door.
uDraw the middle bearing pin Fig. 5 (11) out of the turn hinge and lower door.
uRemove the plastic cap Fig. 5 (10).
CAUTION
Risk of injury if the door tips! u Take good hold of the door. u Set down the door carefully.
u Open the lower door.
u Unscrew the middle turn hinge (2x Torx® 25). Fig. 5 (13) u Lift up the door and set it aside.
4.3.3 Transferring the middle bearing elements
Fig. 5
u Carefully detach the cover panel Fig. 5 (12).
u Turn the middle turn hinge Fig. 5 (13) with the washer Fig. 5 (14) through 180° and screw it firmly into place on the new hinge side (with 4 Nm).
u Turn the cover panel Fig. 5 (12) through 180° and snap it into place again on the new handle side.
6 | * Depending on model and options |