Rangemaster U106140-05 Fitting the oven burner trim, Oven check, Fitting the plinth, Thank you

Page 28

If when you let go of the control knob the burner goes out, the safety device has not held in. Turn off the grill and wait one minute then try again this time holding in the button for slightly longer.

Fitting the oven burner trim

(supplied with some models only)

The loose oven burner trim hooks onto the front of the oven burner bracket.

Oven check

The clock must be set to the time of day before the ovens will work.

Press and hold as above.

At the same time, press - or + until the correct time shows.

Don’t forget it’s a 24 hour clock.

If you make a mistake or press the wrong button, turn off the power supply for a minute or two and start again.

CONTROL KNOB (THERMOSTAT) CHECK

If (AUTO) is flashing, press and release the manual (

)button. Check each oven in turn. Push in and turn the control knob to Mark 9. A series of sparks will occur at the oven electrode and when the oven burner lights the sparking will stop. A small flame will appear on the oven burner, but as this flame is ‘sensed’ by the flame supervision device, the gas flow will come on full after a short delay. Heat each oven for 10 minutes at Mark 9 then turn to Mark 1 and check that the flame size has reduced. Turn off each oven and check that the oven burner goes out.

TIMER AND SOLENOID CHECK

Automatic Operation of Timer: The gas supply to each oven can be controlled by the timer. Set a ‘cooking period’ time by pressing and releasing the (

) button and using the + button to give a time of 2 minutes. By pressing and releasing the ‘stop time’ button ( ) the stop time is displayed. Add 3 minutes

to this time by using the + button. The display will automatically change to show the time of day, the cooking symbol ( ) will go out and (AUTO) will show.

Push in and turn one of the oven knobs to Mark 9, the timer will run until the ‘cook period’ starts, when the oven solenoid will open and the burner will light automatically. The cooking symbol ( ) will show. At the end of the ‘cooking period’ the solenoid will close, the oven burner will go out and the beeper will sound

(the beeper may be stopped by pressing the timer (

)button). The flashing (AUTO) symbol is a reminder to reset to manual operation. Pressing the reset’ button ( ) once to stop the beep and a second time to return to manual, turn off the oven knob.

CONTROL KNOB (THERMOSTAT) CHECK

Set timer to manual. Check each oven in turn. Push in and turn the control knob to Mark 9. A series of sparks will occur at the oven electrode and when the oven burner lights the sparking will stop. A small flame will appear on the oven burner, but as this flame is ‘sensed’ by the flame supervision device, the gas flow will come on full after a short delay. Heat each oven for 10 minutes at Mark 9 then turn to Mark 1 and check that the flame size has reduced. Turn off each oven and check that the oven burner goes out.

Fitting the plinth

Loosen the 3 screws along the front bottom edge of the cooker. Hook the central keyhole over the central screw. Twist and fit each end keyhole over their respective screws. Tighten the fixing screws.

Customer care

Please complete your details in this Guide, inform the user how to operate the cooker and hand over the Instructions.

Thank you.

28

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Installation & Service Instructions U106140 Gas FSD Users GuideInstallation This appliance should not be installed in a boat or caravanBe safe Gas and Electricity onContents Hotplate burners Do not use this to turn the burners off. The gasGriddle WarmerGrill Clock OvensTo set the time of day Auto is showing, you want to reset to manual cooking To time something that’s cooking minute minderTo stop automatically To start and stop the oven automaticallyCooking using the timer Clock Special FeaturesKey Lock To activate the key lockOven cooking ‘S’ Slow cookingOven shelves Oven light HandyrackStorage Oven cooking guide Cleaning your cooker Hotplate burnersGriddle Control Panel and DoorsOven side linings OvensRemoving the Oven Linings Cleaning Table Hotplate Part Finish Recommended Cleaning MethodOutside of cooker Oven and GrillMoving your cooker Troubleshooting Oven temperature getting hotter as the cooker gets older Power supply You think there may be a problem with itPower failure What cleaning materials are recommended for the cooker?General Safety Instructions If you smell gas0800 111 Don’t smokeThis appliance is heavy, take care when moving it Installation Provision of VentilationLocation of Cooker They cannot be converted from one gas to the otherYou will also need the following tools Dear InstallerElectric drill Unpacking the Cooker Positioning the CookerChecking the parts Moving the Cooker LevellingFitting a stability bracket Gas ConnectionPressure testing Electrical ConnectionElectrical checks Hotplate checkFitting the oven burner trim Oven checkFitting the plinth Customer careServicing Notes To Remove the Control PanelTo Remove Hotplate Trays To Remove Side PanelsTo Remove Ignition/light Switch To Change Warmer SwitchTo Remove Clock To Remove a ThermostatTo Change Oven Burner Assembly To Change Grill InjectorTo Change Grill Burner To Change Grill ElectrodeTo Adjust an Oven Door Catch Keep To Change Oven ElectrodeTo Remove Grill Door To Change Oven Door Outer PanelTo Change Oven Door Seal To Change Warmer NeonTo Change Warmer To Change Ignition GeneratorCircuit Diagram Technical Data

U106140-05 specifications

The Rangemaster U106140-05 is a standout model in the world of kitchen appliances, blending a classic aesthetic with modern functionality. Designed to cater to the needs of both casual cooks and culinary enthusiasts, this model is a prime example of quality craftsmanship and innovative technology.

One of the main features of the Rangemaster U106140-05 is its spacious oven capacity. This appliance is designed to accommodate large meals, making it an ideal choice for families or those who love to entertain. The oven features multiple cooking zones, enabling users to prepare various dishes simultaneously. The generous space ensures that even the largest roasts or multiple trays of cookies can be baked to perfection.

The Rangemaster U106140-05 also incorporates advanced cooking technologies which enhance the overall cooking experience. With features such as fan-assisted cooking, heat is evenly distributed around the oven, ensuring that food is cooked uniformly. Additionally, the true convection option is particularly beneficial for baking, as it helps to achieve consistent results across multiple racks, an essential for dedicated bakers.

Energy efficiency is another hallmark of the Rangemaster U106140-05. The oven is designed with temperature accuracy in mind, allowing users to waste less energy while cooking. Its intelligent system also enables precise heating control, minimizing the risk of overcooking or undercooking food items.

The design of the Rangemaster U106140-05 is equally impressive. It showcases a timeless elegance with a range of finishes and colors that can complement any kitchen decor. The ergonomic knobs and handles not only enhance its visual appeal but also ensure ease of use. The wide glass oven door provides easy visibility, allowing users to monitor cooking progress without heat loss.

Safety features are also a priority in this model. The oven is equipped with cool-touch doors, ensuring that the exterior remains safe to touch even during intense cooking sessions. Furthermore, the residual heat indicators provide an additional layer of safety, informing users when the oven is still hot.

Overall, the Rangemaster U106140-05 stands out as an excellent choice for anyone looking to invest in a reliable, stylish, and efficient cooking appliance. With its combination of spacious design, advanced cooking technologies, energy efficiency, and safety features, it truly meets the demands of modern cooking while maintaining a classic charm.
Top Page Image Contents