Rangemaster U109720 - 01 manual Moving your cooker, Troubleshooting

Page 16

Moving your cooker

Switch off the electricity supply.

The cooker is heavy, two people may be required to move it. There are two levelling rollers at the back and also two screw down levelling feet at the front.

Note - For illustration purposes, the Dual Fuel model is shown.

Open the grill door and right hand oven door so that you can get a good grip on the bottom of the fascia panel as you move the oven.

Lift the front of the cooker slightly and pull forward.

Do not move the oven by pulling the door handles or knobs.

Move the oven a bit at a time, checking behind it to make sure the gas hose is not caught. Make sure both electricity cable and gas hose have sufficient slack to move the cooker forward as you go along.

If a stability chain is fitted, release it as you ease the cooker out. Don’t forget to refit it when you replace the cooker.

When you replace the cooker, again check behind to make sure that the electricity cable and gas hose are not caught or trapped.

Troubleshooting

A crack has appeared in the Hob surface

Disconnect the cooker immediately from the power supply and arrange for its repair. Don’t use the cooker until after the repair. See the Customer care leaflet for how to contact a service person.

My Hob is scratched

Have you used the correct cleaning methods?

Pots and pans with rough bottoms, or coarse particles (salt or sand) between the pan and the surface of the hob may cause scratches.

Use the recommended cleaning methods. Make sure pan bottoms are smooth and clean. Tiny scratches are not removable but will become less visible in time as a result of cleaning.

Metal markings on the Hob

Do not slide aluminium or copper pans across the surface. Marks from aluminium and copper pans as well as mineral deposits from water or food can be removed with the cleaning cream.

Steam is coming from the oven

When cooking foods with a high water content (e.g. oven chips) there may be some steam visible at the rear grille. Take care when opening the oven door, as there may be a momentary puff of steam when the oven door is opened. Stand well back and allow any steam to disperse.

The oven fan is noisy

The note of the oven fan may change as the oven heats up - this is perfectly normal.

What cleaning materials are recommended for the cooker?

See the ‘Cleaning’ section for recommended cleaning materials. We do not recommend Mr. Muscle, as it contains chemicals that may damage the surfaces of your cooker.

Grill not cooking properly

Are you using the pan and trivet supplied with the cooker? Is the pan being used on the runners, not the floor of the compartment? Is the grill tray pushed fully back to stop?

The knobs get hot when I use the oven or the grill, can I avoid this?

Yes, this is caused by heat rising from the oven or the grill, and heating them up. Don’t leave the oven door open. Make sure that the grill pan is pushed right back to the ‘back stop’ when grilling.

16

Image 16
Contents Installation & Service Instructions U109720 KitchenerMake sure that the cooker is wired in and switched on Be safeElectricity on Peculiar smellsContents Hob Use only pans that are suitable for ceramic hobsNever cook directly on the surface Grill Remove the pan from the bottom of the grill compartmentOvens Clock To set the time of dayTo time something that’s cooking minute minder To stop automaticallyAuto is showing, you want to reset to manual cooking Cooking using the timerClock Special Features Main Oven shelves Both OvensOven light HandyrackTall oven shelves Page Oven cooking guide Cleaning your cooker GrillHob Control Panel and DoorsMain Oven Tall OvenSide panels of the main oven can be removed Troubleshooting Moving your cookerPower failure Left hand Main oven not coming on when turned on manuallyLeft hand Main oven not coming on when automatic cooking Oven temperature getting hotter as the cooker gets olderPart Finish Recommended Cleaning Method Cleaning Table Outside of cookerOvens General Safety Instructions Clean only parts listed in this guideSpecification of this cooker should not be altered Take care that no water seeps into the applianceDo not use the surface as a cutting board Installation You will also need the following toolsUnpacking the Cooker Positioning the CookerChecking the parts Levelling Moving the CookerFitting a stability bracket Electrical Connection HotplateOven check Fitting the plinthCustomer care Door adjustmentThank you Servicing Notes To Adjust Main Oven Door Catch Keep To Change Grill ControllerTo Remove Grill Door To Remove Main Oven DoorTo Remove or Change a Hotplate Burner To Change Hotplate Control TapsTo Change Hotplate Burner Injector To Change Hotplate Burner ElectrodeTo Adjust the Main Oven Door Catch Keep To Change the Main Oven Door LatchTo Change Tall Oven Door Magnetic Latch To Remove Grill ElementTo Remove Oven Element To Adjust the Oven Door AngleTo change oven light bulb Technical Data DimensionsRatings Ovens1kW 02kW A21.65kW 56kW Key to circuit diagram Colour Code Page Page 271106