Rangemaster RDW6015FI In-1 Function, Memory Function Module, ½ Load Button, To select ½ load

Fig.2-19

ArtNo.800-221 - RDW6015

- 1/2 load

Fig.2-20

ArtNo.800-223

- RDW6015 - 3-in-1

½ Load Button

This function allows the dishwasher to wash dishes using only the upper rack if there are not enough dishes for a full load. This will allow you to save on water and energy consumption.

To select ½ load:

1.Select the programme and then press the ½ load button (Fig.2-19)– the ½ load indicator blinks.

2.Close the door. The programme starts automatically.

To cancel the ½ load

Follow the ‘Cancelling a programme in progress’ instructions.

Note: Please keep in mind that the amount of detergent should also be adapted to the ½ load.

3-in-1 Function

When using ‘3-in-1’ dishwasher tablets the rinse aid and salt functions are no longer useful. It may be advisable to switch the rinse aid off and select the lowest possible setting for water hardness.

Press the ‘3-in-1’ button (Fig.2-20)to deselect the rinse aid function.

If returning to a standard detergent system it is advisable to:

1.Refill both the salt and rinse aid compartments.

2.Switch the water hardness setting to the highest possible position and run for three normal cycles without a load.

3.Readjust the water hardness setting again for local water conditions.

Memory Function Module

If a power cut occurs while the selected washing program is active, the program is not cancelled. The controls use a microprocessor device to memorize the information about the selected washing program. Once the power is returned to the machine, the dishwasher will resume from the point it was interrupted.

10