Fig.5-12
ArtNo.800-0114 - Securing the dishwasher
Fig.5-13 �������
Securing the Dishwasher
Using the two screws supplied, secure the dishwasher to the underside of the worktop (Fig.5-12).
For non-wooden worktops (e.g. marble) two brackets are provided to allow the appliance to be secured to the sides of the adjacent cabinets. Secure the appliance using the two screws at the top of the chassis (Fig.5-13); adjust to the correct width and then screw to the adjacent side panels using suitable screws.
Adjusting the Door Springs
The door balance can be adjusted via two nuts accessed through the two holes in the top of the front frame (Fig.5-14). Using the tool supplied, adjust these until the door remains just open under its own weight and is level when open.
Fitting the Plinth
������� 
��������� ArtNo.800-0114 - Securing the dishwasher
�������
Fig.5-14
�������
���������
�������
Cut clearance in the plinth to allow the door to fully open and seal edges with a suitable silicon sealant to prevent water ingress (Fig.5-15).
ArtNo.800-0119 - Adjusting the door springs
Fig.5-15
