Rangemaster U109941 - 02 manual Positioning the Cooker, Unpacking the Cooker, Moving the Cooker

Page 21

Positioning the Cooker

Fig.7-1shows the minimum recommended distance from the cooker to nearby surfaces.

The cooker should not be placed on a base.

The hotplate surround should be level with, or above, any adjacent work surface. A gap of 75mm should be left between each side of the cooker ABOVE the hotplate level and any adjacent vertical surface.

For non-combustible surfaces (such as unpainted metal or ceramic tiles), this can be reduced to 25mm.

A minimum space of 650mm is required between the top of the hob and a horizontal combustible surface.

Fig.7-2shows the suggested clearances above the cooker.

*Any cooker hood should be installed in accordance with the hood manufacturer’s instructions.

Surfaces of furniture and walls at the sides and rear of the appliance should be heat, splash and steam resistant. Certain types of vinyl or laminate kitchen furniture are particularly prone to heat damage and discolouration. We cannot accept responsibility for damage caused by normal use of the cooker to any material that de-laminates or discolours at temperatures less than 65°C above room temperature.

We recommend a gap of 920mm between units to allow for moving the cooker. Do not box the cooker in – it must be possible to move the cooker in and out for cleaning and servicing.

A clearance of 130mm is required if the cooker is near a corner of the kitchen, to allow the oven doors to open (Fig.7-3). The actual opening of the doors is slightly less, but this allows for some protection of your hand as you open the door.

Unpacking the Cooker

Do not take any packaging off the cooker until it is directly in front of the place in which it is to be installed (unless it will not fit through a door in its outer packaging).

Cut the banding straps and lift the cardboard box off the cooker, leaving the cooker standing on the base packaging. See the loose unpacking sheet.

Moving the Cooker

On no account try and move the cooker while it is plugged into the electricity supply.

The cooker is very heavy, so take great care.

We recommend two people manoeuvre the cooker. Ensure that the floor covering is firmly fixed, or removed to prevent it being disturbed when moving the cooker around. To help you, there are two levelling rollers at the back and two screw- down levelling feet at the front. You will need the levelling tool.

From the back, tilt the cooker forward and remove the rear half of the polystyrene base pack (Fig.7-4). Repeat from the front and remove the front half of the poly base.

ArtNo.090-0009 - 90 2BC cooker min

 

Fig.7-1

 

 

 

 

 

 

 

 

 

����

 

 

����

 

 

 

 

 

 

 

 

 

 

 

���

�����

���

 

 

 

 

 

 

���

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

���������

���������

����������Fig.7-2

ArtNo.090-0016 - 90 2BC min positions above cooker

���������

��������

Fig.7-3

���������

ArtNo.090-0024 - 90 induction door clearances

Fig.7-4

ArtNo.010-0001 Removing the packaging

19

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Professional + Contents Installation and Maintenance SafetyPersonal Safety Peculiar SmellsHob Care CleaningCooker Care  do not use the hob surface as a cutting boardHob Cooker OverviewResidual Heat Indicator, H Pan DetectorAutomatic Heat-up, a Glide-out Grill Child Lock, LBoil Dry Function Ovens  Never close the grill door when the grill is onTo start and then stop the left-hand oven using the Timer Setting the time of dayClock Minute MinderKey Lock Auto is showing, but you want to revert to manual cookingOven Shelves Left-hand Main Oven AccessoriesOven shelves Right-hand Tall Oven Handyrack Main OvenMain Oven Light Tips on Cooking with the Timer Cooking TipsGeneral Oven Tips Meat Fan Oven Cooking TableCleaning Spills Cleaning Your CookerCleaning Burned-on Spills Daily CareControl Panel and Doors Removing the Panels to clean the Enamel Interior ‘Cook & Clean’ PanelsDoor Panel Tall OvenTroubleshooting Oven is not cooking evenly Oven temperature getting hotter as the cooker gets olderOven not coming on An oven light is not workingDear Installer InstallationSafety Requirements Provision of VentilationPositioning the Cooker Unpacking the CookerMoving the Cooker Repositioning the Cooker following Connection Completing the MoveLevelling Lower the Two Rear RollersHob Check Electrical ConnectionGrill Check Oven CheckTo Remove a Side Panel ServicingTo Lift up the Ceramic Hob To Replace a Hob ElementTo Remove the Electronic Timer To Replace a ThermostatTo Replace the Grill Controller To Adjust the Main Oven Door Catch Keep To Adjust an Oven Door Angle The door is heavy, so take care To Replace the Main Oven Door Outer PanelTo Remove an Oven Element Thermal Cut-out To Remove the Grill DoorTo Remove an Oven Inner Back To Remove the Fan Oven ElementTo Replace an Oven Fan To Remove Grill ElementTo Change Oven Light Bulb Key Circuit Diagram OvenCircuit Diagram Hob Technical Data DimensionsConnections DocNo.000-0001 Back cover Rangemaster

U109941 - 02 specifications

The Rangemaster U109941 - 02 is a remarkable appliance that brings elegance, efficiency, and innovation to modern kitchens. Known for its exceptional performance and stylish design, this range integrates cutting-edge technologies with user-centric features, making cooking a delightful experience.

One of the standout features of the Rangemaster U109941 - 02 is its powerful cooking capabilities. With multiple burners and a spacious oven, it allows home chefs to prepare a variety of meals simultaneously. The burners offer precise temperature control, thanks to their advanced ignition system which ensures quick start-ups and stable flames. This precise control is essential for achieving perfect cooking results, whether you are simmering sauces or searing meats.

The oven of the Rangemaster U109941 - 02 is designed with sophisticated cooking technologies such as fan-assisted convection cooking. This feature distributes heat evenly throughout the oven, resulting in consistently cooked dishes and reducing cooking times. Additionally, the oven comes with multiple cooking modes, including baking, broiling, and slow cooking, providing versatility for diverse culinary techniques and recipes.

Energy efficiency is another hallmark of the Rangemaster U109941 - 02. Equipped with advanced insulation and a high-efficiency heating system, it minimizes energy consumption without compromising performance. This eco-friendly approach not only reduces utility bills but also lessens the environmental impact of cooking.

The design of the Rangemaster U109941 - 02 is equally impressive. It features a sleek, modern aesthetic that complements various kitchen styles, from contemporary to traditional. The materials used in construction are durable and easy to maintain, ensuring that this range withstands the rigors of daily cooking while maintaining its visual appeal.

Safety features are also a priority in the Rangemaster U109941 - 02. With flame failure devices and automatic shut-off functions, the appliance provides peace of mind in busy kitchens, ensuring that safety is never compromised.

In summary, the Rangemaster U109941 - 02 is a top-of-the-line cooking range that combines powerful performance, innovative technologies, and stylish design. Whether you are a home cook or a culinary enthusiast, this appliance stands ready to elevate your kitchen experience.
Top Page Image Contents