Rangemaster U109987 - 01 manual Servicing

Page 26

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON

Disconnect from electricity before servicing. Check appliance is safe when you have finished.

8. Servicing

DocNo.081-0013 - Servicing - 90 induction - Elan

Disconnect the cooker from the electricity supply before servicing, particularly before removing any of the following: control panel, side panels, ceramic hob, or any of the electrical components or cover boxes.

Before reconnection, check that the appliance is electrically safe.

1.To Remove a Side Panel

Disconnect from electricity supply.

Pull the cooker forward. Remove the fixing screws.

Remove the retaining screws for each panel (one at the front, two at the rear, and one at each lower front corner of the side panels).

Reassemble in reverse order.

5.To Replace the Light Switch

Disconnect from electricity supply. Remove the control panel (see 1).

Note: The old switch may be destroyed during removal. Remove the old switch from its bezel by gripping the switch body behind the control panel and twisting sharply. Remove the switch bezel by folding back its locking wings and pushing forward. Fit the new bezel to the control panel by first lining up the raised key on its body with the cut-out in the control panel and pushing it in from the front.

Assemble the new switch to the bezel by lining up the key sections and pushing home. Fit the new button by pushing in from the front.

Replace the Control Panel in reverse order and test for correct operation.

2.To Lift up the Ceramic Hob

Disconnect from electricity supply.

Remove the blanking plugs at the top front of each of the side panels to allow access to the hob fixing screws (1 each side) at the top of the side uprights. Remove these screws.

Lift up the ceramic hob at the front and prop in position with a non-metallic prop.

CAUTION: The ceramic hob material is much more sensitive to scratches on the underside than the top.

Take care not to touch or scratch the underside of the ceramic as this will weaken the material and cause the top to shatter.

6.To Remove the Electronic Timer

Disconnect from electricity supply.

Remove the control panel (see 1). Pull off the timer control button(s).

Remove the timer/mounting bracket assembly from the control panel by removing the fixing screws.

Remove the timer from its mounting bracket by depressing the plastic lugs on the timer case, at the same time pulling the unit forward.

Reassemble in reverse order. When replacing the leads, refer to the wiring diagram in this manual. Check the operation of the timer.

3.To Remove the Control Panel

Disconnect from electricity supply.

Remove the two blanking plugs from the handrail fixing brackets. Remove the handrail by unscrewing the 2 end bracket fixing screws (Fig.8-1).

Pull off all the control knobs. Open the grill and right-hand oven door and remove the control panel fixing screws underneath the control panel. The screws directly below the clock are for the clock fixing bracket, so do not remove them at this stage.

Lift the control panel, pull forward and disconnect the wiring from the rear.

Reassemble in reverse order. When replacing leads, refer to the wiring diagram in this manual. Check the operation of the timer.

4.To Replace a Hob Element

Disconnect from electricity supply.

Lift up the ceramic hob (see 2). The Induction Heating Elements (IHE) are now accessible. Note the wire connection positions and element orientation for re-assembly. Disconnect the wires, and remove the element unit and springs. Re- assemble in the reverse order.

Note: The IHE will require commissioning when the hob has been refitted.

7.To Replace a Thermostat

Disconnect from the electricity supply.

Remove control panel (see 1) and lift hob (see 3). Open the oven door. Remove the oven furniture and slide out the oven roof liner if fitted.

For the right-hand oven, remove the thermostat phial cover (two screws). Unclip the thermostat phial from the clips in the oven back.

For the left-hand oven, pull cooker forward to gain access to the cover box at the rear of the cooker. Remove the four screws securing the cover and lift clear.

Feed the thermostat capillary out of the oven. Disconnect the wiring from the thermostat. Remove two screws holding thermostat to mounting panel. Fit new thermostat and reassemble in reverse order. Ensure that the phial is clipped to the oven back with the phial centrally positioned between the clips.

Check the operation of the thermostat.

8.To Replace the Grill Controller

Disconnect from electricity supply.

Remove the control panel and lift up the hob (see 1 and 3). Disconnect the wiring from the controller. Remove the two screws holding the controller to the mounting panel. Fit the new controller and reassemble in reverse order. Check for correct operation.

24

Page 25 Page 27
Image 26
Page 25 Page 27
Contents User Guide Contents Before You Start Installation and MaintenancePersonal Safety Peculiar SmellsCooker Care CleaningHob Care  do not use the hob surface as a cutting boardCooker Overview HobAutomatic Heat-up, a Residual Heat Indicator, HPan Detector Pan Protection Function Glide-out GrillChild Lock, L 0Fig.2-8Left-Hand Multi-function Oven  Never close the grill door when the grill is onOvens Multi-function oven functionsFan assisted oven Fan ovenFanned grilling Conventional oven top and base heatRight-hand tall oven Operating the OvensClock Setting the time of dayTo start and then stop the left-hand oven using the Timer Minute MinderTo activate the key lock Auto is showing, but you want to revert to manual cookingKey Lock To turn off the key lockOven shelves Right-hand Tall Oven AccessoriesOven Shelves Left-hand Main Oven Handyrack Main OvenMain Oven Light General Oven Tips Tips on Cooking with the TimerCooking Tips Cooking Table MeatCleaning Burned-on Spills Cleaning Your CookerCleaning Spills Daily Care‘Cook & Clean’ Panels Control Panel and DoorsRemoving the Panels to clean the Enamel Interior Tall OvenTroubleshooting Oven temperature getting hotter as the cooker gets older Timed oven is not coming on when turned on manuallyTimed oven is not coming on when automatic cooking Food is cooking too slowly, too quickly, or burningSafety Requirements InstallationDear Installer Provision of VentilationMoving the Cooker Positioning the CookerUnpacking the Cooker Levelling Completing the MoveRepositioning the Cooker following Connection Fitting the HandlesHob Check Fitting the Splashback optionalElectrical Connection Grill CheckServicing To Replace an Oven Door To Adjust an Oven Door AngleTo Remove Grill Element  The door is heavy, so take careTo Change the Main Oven Door Latch To Adjust the Main Oven Door Catch KeepTo Replace the Tall Oven Door Outer Panel To Replace an Oven Door SealTo Change Oven Light Bulb To Replace an Oven FanTo Remove the Left-hand Oven Bottom and Top Elements Code Description Colour Code Circuit Diagram OvenKey Circuit Diagram Hob Connections Technical DataDimensions Page Page Page DocNo.000-0001 Back cover Rangemaster

U109987 - 01 specifications

The Rangemaster U109987-01 is a standout appliance designed for modern cooking enthusiasts who appreciate the blend of style, functionality, and advanced technology. As part of Rangemaster’s prestigious line of products, the U109987-01 incorporates a variety of features that cater to both amateur home cooks and seasoned chefs alike.

One of the most prominent characteristics of the Rangemaster U109987-01 is its impressive cooking capacity. With multiple ovens and a generous cooktop area, this range can accommodate large meals and various cooking techniques at once. Whether preparing a grand feast or simple family dinners, the U109987-01 ensures that users have enough space to work efficiently and creatively.

In terms of technology, the U109987-01 boasts advanced cooking features that enhance the cooking experience. It is equipped with multifunctional ovens, offering settings such as fan-assisted, conventional, and grill cooking. This versatility allows users to choose the ideal method for their favorite recipes, resulting in perfectly cooked dishes every time. The precise temperature control ensures that meals are cooked evenly and efficiently.

Another notable feature is the high-powered burners on the cooktop. These burners provide rapid heat-up times and precise temperature control, making it easy to boil, simmer, or sauté with confidence. Additionally, the cooktop often includes a combination of different burner sizes to accommodate pots and pans of various dimensions, catering to different cooking styles and meal preparations.

The design of the Rangemaster U109987-01 is equally impressive, with a sleek and sophisticated aesthetic that fits well into any kitchen décor. The appliance is available in a variety of colors and finishes, allowing homeowners to choose an option that complements their personal style. The intuitive control panel and ergonomic knobs make it easy to operate, ensuring that users can focus on their culinary creations rather than struggling with technology.

Durability and reliability are hallmarks of the Rangemaster brand, and the U109987-01 is no exception. Constructed with high-quality materials, this range is built to withstand the rigors of daily cooking while maintaining a polished appearance. The easy-to-clean surfaces and removable components further enhance its practicality, making maintenance a breeze.

In summary, the Rangemaster U109987-01 is a premium cooking appliance that combines innovative technology with elegant design. Its spacious cooking capacity, advanced features, and stylish aesthetics make it an ideal choice for anyone looking to elevate their culinary journey. Whether for casual home cooking or elaborate entertaining, the U109987-01 is sure to impress.
Top Page Image Contents