Perlick HP15BS, HP15RS manual Checking Product Temperature, Model No

Operation & Installation Manual

Signature Series (HP15 model)

IMPORTANT NOTE: Dependent on the mode and configuration, the controllers have been programmed to only allow a temperature adjustment within a specified range. See chart below for the specified range allowed for your cabinet:

HP15 Models
Description	Model No.	Set Point	Range
Refrigerator	HP15RS	38°F	30°F to 42°F
Beverage Center	HP15BS	42°F	30°F to 48°F
Wine Reserve	HP15WS	45°F	40°F to 68°F

CHECKING PRODUCT TEMPERATURE CLEANING AND OTHER MAINTENANCE

To accurately check the temperature of product stored in the refrigerated compartment insert an accurate thermometer into a plastic (non-breakable) bottle, partially filled with water. Tighten the bottle cap securely.

Place the bottle in the desired area for 24 hours. Refrain from opening the unit during testing period. After 24 hours, check the temperature of the water. Adjust the control settings if necessary.

You Perlick unit is pre-set in order to achieve the recommended temperature range when installed in a 70°F ambient room temperature. Factors which affect the internal temperatures of the refrigerated cabinet include:

•Temperature setting

•Room temperature where installed

•Number of times the door is opened and closed

•Length of times the door is left open

•Style of door installed

•Door gasket sealing and condition

•Amount of time the internal light is illuminated

•Installaion in direct sunlight or near a heart source

CAUTION

Shut off electricity to the unit before cleaning the condenser and other routine maintenance.

To clean stainless steel exterior or interior surfaces, use a soft, non- abrasive stainless steel cleaner to wipe down the surfaces. If you have difficulty finding a good cleaner, try Signature Polish from Signature Limited Laboratory, P.O. Box 13436, Dayton, OH 45413- 0436; or call toll-free at (877) 376-5474. Glass panels can be cleaned using any standard glass cleaner available on the market today.

To clean interior and exterior non-metallic surfaces and removable parts, wash with a mild solution of soap and lukewarm water with a little baking soda. Rinse and dry thoroughly. Avoid getting water on lights, controllers, fan motors and unfinished wood wine rack faces.

CAUTION

Do not use abrasive cleaners or cloths on any of the interior or exterior surfaces or removable parts.

Cleaning the Condenser

The condenser should be cleaned every three (3) months. The condenser is located behind the toe plate (Figure 6). Remove the toe plate and use a soft bristle brush and vacuum to remove the dust and lint. Avoid damaging or crushing the condenser fins or tubing. Upon completion, reinstall the toe-plate.

CAUTION

Failure to clean the condenser could result in temperature loss or mechanical failure. Clean this area every three months.

21