Hoover HND 615 SI manual Description of the Control, Dimensions, Technical Data

DESCRIPTION OF THE CONTROL

F GH I

					E
	A B	C		D
A	"ON/OFF" button	F	"SALT EMPTY" light
B "DELAY START" button		G "PROGRAM STATUS" LEDs/
C	Open door		"DELAY START" time LEDs
		H "PROGRAM SELECTION" LEDs
D	"PROGRAMS" buttons
		I	"OPTION SELECTION" LED
E	"HALF LOAD" button

DIMENSIONS:

		with working top	without working top
Height			82
	cm	85
Depth	cm	60	57,3
Width	cm	60	59,8
Depth with door open	cm	120	117

TECHNICAL DATA:

EN 50242 place load	15
Capacity with pans and dishes	9 persons
Water supply pressure	Min. 0,08 - Max 0,8 MPa
Fuse	(see rating plate)
Power input	(see rating plate)
Supply voltage	(see rating plate)

PROGRAM SELECTION AND SPECIAL FUNCTIONS

(Use in conjunction with programme guide)

Program settings

■Open the door and place dirty dishes inside the appliance.

■Press the "ON/OFF" button .

■After pressing the "ON/OFF" button. The LED for the factory set is "recommended” (which is ideal for full load daily use) or the LED for the "Auto’ Memory" program (see below) will blink.

IMPORTANT

The dishwasher has two very practical functions:

-the "recommended" program

( ) for quick and sure selection;

-the "Auto’ Memory", function which saves a program used at least 3 times consecutively so that if you regularly use the same washing cycle each time you do not have to continually set the program thereby saving time and effort.

■If you wish to select an option, press the option button (the corresponding LED will light).

The option button must be pressed BEFORE the program starts for the option to be accepted.

■To choose another program, press the corresponding button (the relevant LED will blink to confirm the selection).

IMPORTANT

To select the "COLD RINSE" program, simultaneously press the "RAPID" program button and "HALF LOAD" option button (the relevant LEDs will blink, confirming the selection).

■To start the program, press the selected program button again to confirm. The relevant LED will stop blinking and remain on and, when the door is shut, the program will start automatically.

IMPORTANT

To confirm the “COLD RINSE” program, simultaneously press the “RAPID” program button and the “HALF LOAD” option button (the relevant LEDs will stop blinking and remain on to confirm the selection).

If the previously described operations were performed with the door open, the program will not start until the door is closed.

Program interruption

Opening the door when a program is running is not recommended especially during the main washing and final hot rinse phases. However, if the door is opened while a program is running (for example, to add dishes) the machine stops automatically.

Close the door, without pressing any buttons. The cycle will start from where it left off (if it is necessary, the appliance will make a short thermal anti-shock programme before).

IMPORTANT

A running program can be interrupted without opening the door by pressing the "ON/OFF" button. In this case, simply press the "ON/OFF" button again to restart the cycle from where it left off.

22 23