Hoover HND 615 SI manual Installation in Fitted Kitchens, Water Softener Unit, Type

INSTALLATION IN FITTED KITCHENS

Fitting between existing cabinets

■ The height of the dishwasher, 85 cm, has

been designed in order to allow the

machine to be fitted between existing

cabinets of the same height in modern

fitted kitchens. The feet can be adjusted

so that correct height is reached.

■ The laminated top of the machine does

not require any particular care since it is

heatproof, scratchproof and stainproof

(fig. 5).

■ The work top can be easily adjusted to

line it with the top of existing cabinets;

this is done by moving it by 5 mm each

time up to a maximum of 25 mm.

Underneath existing work top

(when fitting beneath a work top)

■In most modern fitted kitchens there is only one single work top under which cabinets and electrical appliances are fitted. In this case remove the work top of the dishwasher by unscrewing the screws under the rear edge of the top (fig. 6).

■The height will then be reduced to 82 cm, as scheduled by the International Regulations (ISO) and the dishwasher will fit perfectly under the kitchen working top (fig. 7).

WATER SOFTENER UNIT

Depending on the source of the supply, water contains varying amounts of limestone and minerals which are deposited on the dishes leaving whitish stains and marks.

The higher the level of these minerals present in the water, the harder the water is. The dishwasher is fitted with a water softener unit which, through the use of special regenerating salt, supplies softened water for washing the dishes. The softener unit can treat water with a hardness of up to 60°fH (French grading) or 33°dH (German grading) through five different settings.

The degree of hardness of your water can be obtained from your water supply company.

If your water is at level 0, you need not use any regenerating salt, nor need you make any adjustment, as your water is soft.

According to the degree of hardness of your water, regulate the softener unit in the following way:

1.remove the lower rack. Unscrew and remove the cap from the salt dispenser located in the bottom of the tub (fig. A"1");

2.turn the selector screw to the required position with a screwdriver or a knife.

■ To adjust it, unscrew the two screws at

the back and fix the top in the position

required (fig. 6).

Regulating the water softener

The table below lists different degrees of water hardness with the corresponding set- ting for the softener unit.

TYPE 1

5 6 7

598

556/573

Opening the door Closing the door

*The water softener unit is set in the factory at level 2, as this is suitable for the majority of users.

TYPE 2

	Water	Water
	hardness	hardness	Use of	Water	N°
Level	°fH	°dH	regenerating	softener	of
			salt	setting	washes
	(French)	(German)
0	0-9	0-5	NO	FREE	50
1	10-30	6-16	YES	position N.1
*2	31-40	17-22	YES	N.2	40

Put your hand into the recess and pull.

If the machine comes open while it is working, an electrical safety device automatically switches everything off.

IMPORTANT

For the machine to work properly, the door should not be opened while it is in operation.

Place the baskets in the machine.

Make sure that both the spray arms are free to rotate and are not obstructed by cutlery, crockery or pans. Close the door, pressing on it to make sure it is firmly shut.

				position		30
3	41-50	23-27	YES	position N.3
4	51-60	28-33	YES	position	N.4	20

8 9