AMX NXD/NXT-1500VG, NXD/NXT-1700VG manual Installing an NXT-BP into the NXA-BASE/B, Top view

Touch Panel Accessories

The battery base cannot be "hot-swapped". A panel receiving power through a connected 12 VDC-compliant power supply cannot have a battery base installed onto the bottom of the panel while powered. POWER OFF the panel before installing the NXA-BASE/B.

"Hot swapping" could damage the base and cause it not to be recognized by the panel.

5.Gently apply downward pressure until the panel is securely mounted to the battery base (FIG. 29).

Top view Bottom view

Interface connector (male)

Alignment	Panel Interface
	connector
pegs
	(female)

FIG. 29 NXA-BASE/B shown aligning with NXT panel

Captive fasteners

6.Firmly grip both the panel (from the side) and battery base (from below) together.

7.Gently place the touch panel LCD facedown onto a soft cloth (this prevents scratching of the LCD while the battery base is being secured).

8.Locate the captive fasteners on the underside of the battery base by angling the base combo slightly forwards.

9.Secure each captive fastener head using a grounded flat-head screwdriver until the NXA-BASE/B is securely attached to the underside of the NXT Modero touch panel.

10.Firmly grip the panel LCD/base combo and gently rotate the unit back onto the base.

Installing an NXT-BP into the NXA-BASE/B

The battery base does not directly connect to a power supply, but rather receives its power directly from the Modero panel, through the Panel Interface connector.

Remove any connectors from the rear of the Modero NXT panel before continuing with the installation of the batteries. Power can only be supplied after the batteries have been installed.

1.With the panel mounted on the battery base, open the battery compartment (FIG. 30) by pulling the handle outwards. This compartment houses two NXT-BP batteries.

2.Install the NXT-BP battery. label-side down.

VG-Series Modero Touch Panels 47