AMX NXD/NXT-1200VG, NXD/NXT-1500VG, NXD/NXT-1700VG Front Panel Components, Rear Panel Components

Introduction

1200VG Panel Specifications (Cont.)

Front Panel Components:
Light sensor:	• Photosensitive light detector for automatic adjustment of the panel
	brightness (a dim room results in a dimmer LCD display and a bright
	room results in a brighter LCD display).
	Note: The light sensor can be adjusted via the Sensor Setup Page section
	on page 158.
Motion sensor (PIR):	• Proximity Infrared Detector to wake the panel when the panel is
	approached.
	• Activation range: + 20° vertically from center and + 45° horizontally
	from center.
	Note: The motion sensor can be adjusted via the Sensor Setup page
	(Sensor Setup Page section on page 158).
Front setup access button:	• Provides both access to the Setup and Calibration pages and toggles the
	panel between a "sleep" and "wake" state.
	- When wired, "sleep" status means the backlight is Off.
	- When battery operated, wireless "sleep" status means the touch panel
	base is either Off or "suspended".
Microphone:	• Used for intercom applications (requires an optional NXA-AVB/RGB or
	NXA-AVB/ETHERNET Breakout Box).
Speakers:	• Stereo output with a frequency response of 450 Hz - 7 KHz
Rear Panel Components:	(Side panel location on NXD-Wall Mount panels)
RGB connector	• This connector is only made available only by using an NXA-RGB
	interface card installed within the touch panel. This card is sold either as
	part of an RGB Kit configuration or within the NXA-RGBKIT upgrade kit
	for previous Video Kit fitted VG-Series panels.
	• Routes RGB and computer control pass-thru signals to/from a Modero
	panel up to 200 ft. (60.9 m).
	• RJ-45 connector provides RGB/Component video signals (being routed
	from the rear RGB/Component input ports) and touch control information
	to the RJ-45 RGB connector on the NXA-RGB card (installed within the
	panel). This connector routes VGA and Component video signals.
Audio/Video connector:	• RJ-45 connector for communication of differential audio/video signals
	to/from the touch panel (panel type dependant). This connector receives
	Composite video, Stereo (left/right) audio, and microphone audio.
	• Video is received via the NXA-AVB/RGB Breakout Box. Configuring
	video windows for playback is done using TPDesign4.
	• In-bound audio (from the Breakout Box) gets directed to the speakers.
	• Out-bound audio is sent from the on-board microphone (on the
	front-panel). Selecting audio files for playback is configured through
	TPDesign4.
Ethernet 10/100 port:	• RJ-45 port for 10/100 Mbps communication. The Ethernet port
	automatically negotiates the connection speed (10 Mbps or 100 Mbps),
	and whether to use half duplex or full duplex mode.
	• These panels communicate with the NetLinx® Master using the ICSP
	protocol over Ethernet.
Ethernet 10/100 LEDs:	• LEDs show communication activity and connection information:
	A-activity - Yellow LED lights when receiving or transmitting Ethernet
	data packets.
	L-link - Green LED lights when the Ethernet cables are connected and
	terminated correctly.

4 VG-Series Modero Touch Panels