AMX NXD/NXT-1700VG, NXD/NXT-1500VG, NXD/NXT-1200VG manual Install the NXA-RGB Card Component NXT

Touch Panel Accessories

5.While maintaining the 25° angle alignment on the new module, push it in firmly until the contact pins are completely inside the connector and the card "snaps" into place (FIG. 18).

6.Push the card downward (to the main board) until the side braces snap atop the NXA-PCI80211G and hold it in place.

Antennas connectors

Connection point between the braces and the mini-PCI card

FIG. 18 Installation of the mini-PCI card connector on main board

7.Locate the terminal ends of the antennas and apply downward pressure to "snap" them onto their gold-tipped counterparts on the mini-PCI card (FIG. 18). Carefully push down on each connector to verify it is securely joined to the card.

It is recommended that any upgrade of internal equipment be done simultaneously in order to reduce the risk of damage to internal components.

If you are also installing an NXA-RGB card (as part of an NXA-RGBKIT), refer to the installation procedures on page 22 before replacing the outer housing.

Step 3: Install the NXA-RGB Card Component (NXT)

1.Discharge any static electricity from your body by touching a grounded metal object.

2.Locate the RGB card’s slot connector on the main board and align it with its counterpart on the bottom of the NXA-RGB card.

3.Carefully, but firmly, insert the NXA-RGB card into the RGB connector slot on the main board until both the card rests atop the four raised securing holes and the RGB RJ-45 connector is evenly aligned with the other RJ-45 connectors on the back of the panel.

4.Use a grounded Phillips-head screwdriver to secure the four NXA-RGB pan-head securing screws to the raised securing holes on the main board.

5.To complete the upgrade process, either upgrade the remaining component (Step 3) or close and re-secure the enclosure using the procedures in Step 5: Close and Resecure the NXT Panel Enclosure section on page 41.

VG-Series Modero Touch Panels 39